A 3–6-GHz Highly Linear I-Channel Receiver With Over +3.0-dBm In-Band P 1dB and 200-MHz Baseband Bandwidth Suitable for 5G Wireless and Cognitive Radio Applications
- 1 August 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 66 (8) , 3134-3147
Abstract
A highly linear I-channel receiver prototype is presented for a 3-6-GHz broadband radio system with a 200-MHz baseband bandwidth and verified to operate under congested spectrum environments. A direct conversion receiver developed from this prototype is suitable for a cognitive radio, a fifth-generation (5G) receiver, and other wireless systems with a total (in-band signal plus blocker) power of above -6.0 dBm. The broadband receiver consists of a low-noise transconductance amplifier (LNTA), a passive mixer, a wideband transimpedance amplifier, and a power-efficient minimally invasive baseband filter. The LNTA with high linearity employs a cross-coupled structure and resistive degeneration to achieve low noise and high linearity simultaneously. The common-gate-based LNTA achieves 2.3-dB noise figure in simulation. Fabricated in a mainstream 40-nm CMOS technology, the worst case measured system noise figure is under 5.8 dB at 3-MHz baseband frequency, and the conversion gain is larger than 12.8 dB with passband variations under 2 dB from 1- up to 200-MHz signal bandwidth. Over 3-6 GHz, the receiver's in-band input third-order intercept point (IIP3) and input P1db are higher than 15.1 and 3.0 dBm, respectively, whereas the power consumption varies from 64.1 to 69.6 mW.Keywords
Funding Information
- National Science Foundation (ECCS-1547447)
This publication has 31 references indexed in Scilit:
- A Switched-Capacitor RF Front End With Embedded Programmable High-Order FilteringIEEE Journal of Solid-State Circuits, 2016
- A Noise-Cancelling Receiver Resilient to Large Harmonic BlockersIEEE Journal of Solid-State Circuits, 2015
- 19.3 Reconfigurable SDR receiver with enhanced front-end frequency selectivity suitable for intra-band and inter-band carrier aggregation2015
- Field-Programmable LNAs With Interferer-Reflecting Loop for Input Linearity EnhancementIEEE Journal of Solid-State Circuits, 2015
- A 0.9 V 0.4–6 GHz Harmonic Recombination SDR Receiver in 28 nm CMOS With HR3/HR5 and IIP2 CalibrationIEEE Journal of Solid-State Circuits, 2014
- Wide-Band Inductorless Low-Noise Transconductance Amplifiers With High Large-Signal LinearityIEEE Transactions on Microwave Theory and Techniques, 2014
- A Highly Linear 1 GHz 1.3 dB NF CMOS Low-Noise Amplifier With Complementary Transconductance LinearizationIEEE Journal of Solid-State Circuits, 2014
- A 0.5-to-3 GHz Software-Defined Radio Receiver Using Discrete-Time RF Signal ProcessingIEEE Journal of Solid-State Circuits, 2014
- 3.8 A fully integrated highly reconfigurable discrete-time superheterodyne receiver2014
- Distortion in elementary transistor circuitsIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1999