Effects of Fuel Injection and Ignition on the Direct-Start Process of a Gasoline Direct Injection (GDI) Engine
Authors:
Open Access
- 1 January 2025
- journal article
- Published by Tech Science Press in Fluid Dynamics & Materials Processing
- Vol. 21 (2) , 405-426
Abstract
During the highly transient process of the direct-start in a four-cylinder GDI engine, each cylinder exhibits specific characteristics in terms of in-cylinder conditions and energy demands, necessitating different control for each cylinder. However, recent studies have paid insufficient attention to cylinders other than the first starting cylinder. This paper proposes a comprehensive control strategy based on experimental data from the direct-start process of the second, third, and fourth cylinders, aiming to enhance the characteristics of combustion and emission performance through the optimization of injection timing, equivalence ratio, and ignition timing. The research findings indicate that the second cylinder should inject fuel approximately 10 ms after the first cylinder ignites to mix thoroughly the fuel with air. The ignition timing of the second cylinder should be close to the highest point of the piston movement to minimize hindrance to the piston compression process. The third and fourth cylinders should adopt a delayed injection timing strategy to prevent the escape of injected fuel caused by low engine speed. The optimal ignition timing for the third cylinder is 20°CA BTDC, while the fourth cylinder should be ignited earlier due to its stronger airflow and faster formation of a mixture that can be ignited. As the fuel injection quantity increases, the power output of the three cylinders enhances, but at the same time, emissions also increase. Therefore, their optimal equivalence ratios are determined as 1.2, 1.4, and 1.2, respectively, striking a balance between combustion and emission performances.Keywords
This publication has 32 references indexed in Scilit:
- Effects of a start-stop system for gasoline direct injection vehicles on fuel consumption and particulate emissions in hot and cold environmentsEnvironmental Pollution, 2022
- Effect of injection timing on combustion, emission and particle morphology of an old diesel engine fueled with ternary blends at low idling operationsEnergy, 2022
- Effect of equivalence ratio on spark ignition combustion of an air-assisted direct injection heavy-fuel two-stroke engineFuel, 2022
- An efficiency and robustness analysis of warm-start mathematical models for idle and waiting times optimization in the flow shopComputers & Industrial Engineering, 2022
- Experimental study on the temperature characteristics of a diesel particulate filter during a drop to idle active regeneration processApplied Thermal Engineering, 2020
- Review on spray, combustion, and emission characteristics of recent developed direct-injection spark ignition (DISI) engine system with multi-hole type injectorFuel, 2020
- Effect of initial start conditions on combustion and rotation characteristics of first firing cycle during direct-start process for a GDI engineApplied Thermal Engineering, 2017
- Study on the combustion and hydrocarbon emission characteristics of direct injection spark-ignition engines during the direct-start processEnergy Conversion and Management, 2015
- Model-based cold-start speed control scheme for spark ignition enginesControl Engineering Practice, 2010
- Direct startMTZ Worldwide, 2006