Microstructural and Strength Changes During Multi-Axial Forging of Ta-10 wt% W and its Comparison with Ta
Authors:
Open Access
- 28 January 2025
- journal article
- research article
- Published by Springer Nature in Metals and Materials International
- Vol. 31 (9) , 2541-2550
Abstract
The study aims to bring out the effect of microstructural modification and W addition in TaW on the strength as these alloys find applications in ballistics, high temperature and corrosive environments. Coarse-grained tantalum-10 wt% tungsten (Ta-10 W) was multi-axially forged (MAF) to 3, 6, and 9 passes corresponding to equivalent strains of 2.4, 4.8 and 7.2, respectively. The MAF Ta-10 W samples were characterized for their microstructural and mechanical properties. The average grain size decreased from 20 μm in the starting material to 3 μm after 3 passes and to 0.38 μm after 9 passes. The fraction of high angle grain boundaries ( $$\:{f}_{hagb}$$ ) increased from 0.26 (3 passes) to 0.56 (9 passes) and the fraction of recrystallized grains ( $$\:{f}_{recry}$$ ) increased from 0.31 (3 passes) to 0.92 (9 passes). The yield stress increased from 964 MPa after 3 passes to 1202 MPa after 9 passes. It was found that the contribution from GBs as compared to that from dislocations was lower after 3 passes than after 9 passes. The addition of tungsten to tantalum increased the flow locus during MAF and yield stress of MAF samples to almost double as compared to Ta. As compared to MAF Ta, MAF Ta-10 W showed finer grains, higher $$\:{f}_{hagb}$$ , and higher $$\:{f}_{recry}$$ . Graphical Abstract
Keywords
Funding Information
- Bhabha Atomic Research Centre
This publication has 35 references indexed in Scilit:
- A broad study of tantalum strength from ambient to extreme conditionsActa Materialia, 2022
- Effect of Tungsten Addition on Shock Loading Behavior in Ta–W System: A Molecular Dynamics Study2022
- The evolution of deformation microstructure in electron beam melted Ta-2.5W alloy during cold rollingFusion Engineering and Design, 2017
- Assessment of geometrically necessary dislocation levels derived by 3D EBSDActa Materialia, 2015
- Predicting Texture Evolution in Ta and Ta-10W Alloys Using Polycrystal PlasticityJOM, 2015
- A strain-rate and temperature dependent constitutive model for BCC metals incorporating non-Schmid effects: Application to tantalum–tungsten alloysInternational Journal of Plasticity, 2014
- Strengthening mechanisms in nanostructured high-purity aluminium deformed to high strain and annealedActa Materialia, 2009
- The effect of grain boundaries on the athermal stress of tantalum and tantalum-tungsten alloysMetallurgical and Materials Transactions A, 2002
- Burnup of some refractory metals in a fusion neutron spectrumJournal of Nuclear Materials, 1994
- Activation energy and activation volume of dislocation movement through randomly distributed point obstaclesPhysica Status Solidi (a), 1981