Abstract
HTS conductors for practical applications are made using three oxide compounds REBa2Cu3O7–x (RE-123; RE = Y or rare earth), (Bi,Pb)2Sr2Ca2Cu3O10+y and Bi2Sr2CaCu2O8+δ that have Tc above liquid nitrogen temperature. Except for chemical deposition technologies for thin films and coated conductors, other methods for producing technical superconductor wires use powders as a starting material for filament cores in powder-in-tube processing or as targets for sputtering. In addition, bulk materials directly produced from powders were also technologically exploited in certain key niche areas of power engineering. These include current leads, fault current limiting (FCL) devices and magnetic shielding. The low thermal conductivity of the HTS oxides coupled with the lack of joule heating below Tc essentially reduces the heat leakage during transporting power currents between ambient and liquid helium temperatures when compared with a conventional metallic copper leads or LTS leads (for current transfer from 4.2 K to 1.8 K). These components are usually in the form of an assembly of wires or tapes or large diameter rods or tubes. The bulk current leads were the first commercial application of HTS materials (Bock et al., 1995) and still occupy a small niche for special applications when extremely low thermal losses are required (Takeda et al., 2017). The very low thermal conductivities of bulk Y-123 (close to that of stainless steel) and particularly Bi-2223 (two to five times smaller depending on temperature) and Bi-2212 (an order of magnitude smaller) are the clear reasons for that (Ryan, 2003; Yamada, 1996).