A conventional thermo-mechanical process of Al–Cu–Mg alloy for increasing ductility while maintaining high strength
Authors:
- Y.J. HuangYHY.J. Huang
- Z.G. ChenZCZ.G. Chen
- Z.Q. ZhengZZZ.Q. Zheng
- 1 March 2011
- journal article
- Published by Elsevier in Scripta Materialia
- Vol. 64 (5) , 382-385
Abstract
No abstract availableKeywords
This publication has 24 references indexed in Scilit:
- Severe plastic deformation processing of Al–Cu–Li alloy for enhancing strength while maintaining ductilityScripta Materialia, 2010
- Low-temperature superplasticity of Al–Mg–Sc alloy produced by friction stir processingScripta Materialia, 2009
- A study on the mechanical properties of cryorolled Al–Mg–Si alloyMaterials Science and Engineering: A, 2008
- Optimizing the strength and ductility of fine structured 2024 Al alloy by nano-precipitationActa Materialia, 2007
- Precipitation Hardening in Al-Cu-Mg Alloys: Analysis of Precipitates, Modelling of Kinetics, Strength PredictionsMaterials Science Forum, 2006
- Development of ultrafine grained high strength Al–Cu alloy by cryorollingScripta Materialia, 2006
- High strain rate superplasticity in a commercial Al–Mg–Sc alloyScripta Materialia, 2004
- On the nucleation and growth of Al2CuMg (S′) in AlLiCuMg and AlCuMg alloysScripta Metallurgica, 2003
- Coexistence of clusters, GPB zones, S″-, S′- and S-phases in an Al–0.9% Cu–1.4% Mg alloyActa Materialia, 2000
- Dynamic deformation behavior of AlZnMgCu alloy matrix composites reinforced with 20 Vol.% SiCActa Metallurgica et Materialia, 1993