Silicate Sawing Sludge Recovery in Thermo Eco-Mortar for Macroporous Plaster
Open Access
Abstract
The aim of this research was to develop a new eco-product to find a correct recovery of silicate sawing sludge by means of waste management according to European criteria. To reach this goal, a thermal eco-mortar for a macroporous plaster was developed. The main characteristics of a plaster that influence the correct choice of the mortar are good adherence with underlying support, impermeability, thermal and acoustic insulation, mechanical resistance and ability to allow transpiration processes through the wall’s perimeters. Plaster is a mortar composed of a binding part that incorporates sand with a selected particle size distribution, not greater than 2 mm. The sludge, to be used as plaster, must satisfy requirements related to thermal insulation, resistance to moisture, mechanical resistance and good injection. For this purpose, low-content metals sludge, derived from the Luserna stone flaming and cutting slabs, are to be reused as a substitute for the sands and fine particles, respectively, that are normally used to produce plasters. The laboratory tests carried out on the finished product, in accordance with European standards, are as follows: water absorption, specific density, flexural and compressive strength, before and after freeze and thaw cycles, pull out, salt crystallisation cycle resistance and thermal conductivity. Chemical and leaching tests were carried out to verify the possible release of heavy metals into the environment after installation. The product quality was demonstrated as the cement mortars, incorporating the metals, did not allow their release in nature. A sludge recovery, in an unaltered state, was provided to reduce any costs connected to a pre-treatment and to make recovery economically advantageous for the stone sector.Keywords
This publication has 17 references indexed in Scilit:
- Eco-efficient cements: Potential economically viable solutions for a low-CO2 cement-based materials industryCement and Concrete Research, 2018
- Investigation of the potential use of waste from ornamental stone processing after heat treatment for the production of cement-based pasteConstruction and Building Materials, 2018
- Performance of mortar and concrete incorporating granite sludge as cement replacementConstruction and Building Materials, 2018
- Mechanical, environmental and economic performance of structural concrete containing silica fume and marble industry waste powderConstruction and Building Materials, 2018
- Properties of concrete containing polished granite waste as partial substitution of coarse aggregateConstruction and Building Materials, 2017
- A study on environmental and economic impacts of using waste marble powder in concreteJournal of Building Engineering, 2017
- Eco-friendly Use of Granite Fines Waste in Building BlocksProcedia Environmental Sciences, 2016
- Granite Sludge Reuse in Mortar and ConcreteJournal of Applied Sciences, 2013
- Characterization of eco-cement paste produced from waste sludgesChemosphere, 2011
- Reuse of limestone cutting waste in the production of mortars and plasters for building restoration