Water Peel-Off Transfer of Electronically Enhanced, Paper-Based Laser-Induced Graphene for Wearable Electronics
Open Access
- 16 November 2022
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 16 (12) , 20633-20646
Abstract
Laser-induced graphene (LIG) has gained preponderance in recent years, as a very attractive material for the fabrication and patterning of graphitic structures and electrodes, for multiple applications in electronics. Typically, polymeric substrates, such as polyimide, have been used as precursor materials, but other organic, more sustainable, and accessible precursor materials have emerged as viable alternatives, including cellulose substrates. However, these substrates have lacked the conductive and chemical properties achieved by conventional LIG precursor substrates and have not been translated into fully flexible, wearable scenarios. In this work, we expand the conductive properties of paper-based LIG, by boosting the graphitization potential of paper, through the introduction of external aromatic moieties and meticulous control of laser fluence. Colored wax printing over the paper substrates introduces aromatic chemical structures, allowing for the synthesis of LIG chemical structures with sheet resistances as low as 5 Ω·sq-1, translating to an apparent conductivity as high as 28.2 S·cm-1. Regarding chemical properties, ID/IG ratios of 0.28 showcase low defect densities of LIG chemical structures and improve on previous reports on paper-based LIG, where sheet resistance has been limited to values around 30 Ω·sq-1, with more defect dense and less crystalline chemical structures. With these improved properties, a simple transfer methodology was developed, based on a water-induced peel-off process that efficiently separates patterned LIG structures from the native paper substrates to conformable, flexible substrates, harnessing the multifunctional capabilities of LIG toward multiple applications in wearable electronics. Proof-of concept electrodes for electrochemical sensors, strain sensors, and in-plane microsupercapacitors were patterned, transferred, and characterized, using paper as a high-value LIG precursor for multiples scenarios in wearable technologies, for improved sustainability and accessibility of such applications.Keywords
Funding Information
- European Regional Development Fund (BEST -ALT20-03-0247-FEDER113469 | LISBOA-01-0247-F)
- H2020 Research Infrastructures (101008701)
- H2020 European Research Council (787410)
- Funda??o para a Ci?ncia e a Tecnologia (DFA/BD/8606/2020, UI/BD/151295/2021, UIDB/50025/2020-2023)
This publication has 59 references indexed in Scilit:
- Preparation and characterization of side-chain liquid crystal polymer/paraffin composites as form-stable phase change materialsJournal of Materials Chemistry A, 2015
- Flexible and Stackable Laser-Induced Graphene SupercapacitorsACS Applied Materials & Interfaces, 2015
- Laser-induced porous graphene films from commercial polymersNature Communications, 2014
- Graphene synthesisDiamond and Related Materials, 2014
- High modulus and high strength ultra-thin polyimide films with hot-stretch induced molecular orientationMaterials Chemistry and Physics, 2013
- Graphenes Bonding Forces in GraphiteActa Physica Polonica A, 2007
- Facile synthetic approach to novel core-extended perylene carboximide dyesChemical Communications, 2005
- An Extended Method for the Practical Evaluation of the Standard Rate Constant from Cyclic Voltammetric DataElectroanalysis, 2004
- Theory and Application of Cyclic Voltammetry for Measurement of Electrode Reaction Kinetics.Analytical Chemistry, 1965
- Formulae for Dielectric Constant of MixturesProceedings of the Physical Society. Section B, 1957