The effect of insert surface roughness in part production with inserted powder injection molding method
Authors:
Open Access
- 1 January 2023
- journal article
- research article
- Published by National Library of Serbia in Science of Sintering
- Vol. 55 (1) , 89-101
Abstract
The Powder Injection Molding (PIM) method is widely used in the production of parts with complex geometries and small volumes. To solve the volume limitation in PIM, the Inserted Powder Injection Molding (IPIM) method was developed. In this study, the effect of insert surface roughness on shear strength was investigated using the IPIM method in the production of WC-9%Co parts. Firstly, inserts with five different surface roughness (Ra, ?m), 1.5 - 2.1 - 3.3 - 4 - 4.6, were prepared from 4340 steel for the research. WC feedstock was injected onto the prepared inserts. Following the injection process, the samples were subjected to debinding and sintering processes. Compression tests were performed on sintered specimens, and the effect of surface roughness on diffusion bonding strength was investigated. As a result of the experiments, it was determined that the shear strength increases with the increase of the insert surface roughness. The maximum shear strength (118.4 MPa) was obtained in samples with an insert surface roughness of 4.6 ?m.Keywords
This publication has 39 references indexed in Scilit:
- Novel fabrication of injection-moulded ceramic parts with large section via partially water-debinding methodJournal of the European Ceramic Society, 2012
- Co-sintering of M2/17-4PH Powders for Fabrication of Functional Graded Composite LayersJournal of Composite Materials, 2009
- Effect of Surface Preparation on CLAM/CLAM Hot Isostatic Pressing diffusion bonding jointsJournal of Nuclear Materials, 2009
- Two-material powder injection molding of functionally graded WC–Co componentsInternational Journal of Refractory Metals and Hard Materials, 2009
- Pressureless Sintering of 3Y‐TZP/Stainless‐Steel Composite LayersJournal of the American Ceramic Society, 2008
- The effects of various finished surfaces on diffusion bondingModelling and Simulation in Materials Science and Engineering, 2008
- Effect of Zn alloy interlayer on interface microstructure and strength of diffusion-bonded Mg–Al jointsScripta Materialia, 2008
- The Optimal Surface Roughness Condition on Diffusion BondingMATERIALS TRANSACTIONS, 2003
- Diffusion bonding of ceramicsJournal of Materials Science, 1992
- Diffusion bonding stainless steel to alumina using aluminium interlayersJournal of Materials Science, 1982