Respirable Silica Dust Suppression During Artificial Stone Countertop Cutting
Open Access
- 17 October 2014
- journal article
- research article
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 59 (1) , 122-126
Abstract
To assess the relative efficacy of three types of controls in reducing respirable silica exposure during artificial stone countertop cutting with a handheld circular saw. A handheld worm drive circular saw equipped with a diamond segmented blade was fitted with water supply to wet the blade as is typical. The normal wetted-blade condition was compared to (i) wetted-blade plus ‘water curtain’ spray and (ii) wetted-blade plus local exhaust ventilation (LEV). Four replicate 30-min trials of 6-mm deep, 3-mm wide cuts in artificial quartz countertop stone were conducted at each condition in a 24-m 3 unventilated tent. One dry cutting trial was also conducted for comparison. Respirable cyclone breathing zone samples were collected on the saw operator and analyzed gravimetrically for respirable mass and by X-ray diffraction for respirable quartz mass. Mean quartz content of the respirable dust was 58.5%. The ranges of 30-min mass and quartz task concentrations in mg m −3 were as follows—wet blade alone: 3.54–7.51 and 1.87–4.85; wet blade + curtain: 1.81–5.97 and 0.92–3.41; and wet blade + LEV: 0.20–0.69 and −3 mass and 44.6mg m −3 quartz. There was a statistically significant difference ( α = 0.05) between the wet blade + LEV and wet blade only conditions, but not between the wet blade + curtain and wet blade only conditions, for both respirable dust and respirable silica. Sawing with a wetted blade plus LEV reduced mean respirable dust and quartz task exposures by a factor of 10 compared to the wet blade only condition. We were unable to show a statistically significant benefit of a water curtain in the ejection path, but the data suggested some respirable dust suppression.Keywords
This publication has 7 references indexed in Scilit:
- Outbreak of silicosis in Spanish quartz conglomerate workersInternational Journal of Occupational and Environmental Health, 2013
- Determinants of Respirable Silica Exposure in Stone Countertop Fabrication: A Preliminary StudyJournal of Occupational and Environmental Hygiene, 2013
- Occupational Exposure to Silica in Construction Workers: A Literature-Based Exposure DatabaseJournal of Occupational and Environmental Hygiene, 2013
- Artificial Stone SilicosisChest, 2012
- Silicosis en trabajadores de conglomerados de cuarzoArchivos de Bronconeumología, 2011
- Assessment of Silica Exposure and Engineering Controls During TuckpointingApplied Occupational and Environmental Hygiene, 2003
- Silica Exposure During Granite Countertop FabricationApplied Occupational and Environmental Hygiene, 1999