INVESTIGATION OF THE STRESS-STRAIN STATE DURING NEW COMBINED DEFORMATION TECHNOLOGY
Open Access
- 30 June 2025
- journal article
- Published by Karagandy University of the name of academician E.A. Buketov in Eurasian Physical Technical Journal
- Vol. 22 (2 (52)) , 109-120
Abstract
This paper presents the results of finite element modeling of a novel technology of combined deformation by radial-shear broaching and traditional drawing. Using DEFORM program, the parameters of stress-strain state and deformation forces were studied. A range of models with varying initial diameters of the workpiece, single and total compressions, and different temperatures of heating the workpiece were considered. It was revealed that the optimal conditions occurred at 30-25-20 scheme at a temperature of 900°C. However, this scheme can be recommended when the strength of the deforming equipment is sufficient. In other cases, it is necessary to select a scheme that allows for deformation without exceeding the limiting loads.Keywords
This publication has 12 references indexed in Scilit:
- Gradient microstructure formation in carbon steel barsJournal of Materials Research and Technology, 2024
- Modeling and development of technology for smelting a complex alloy (ligature) Fe-Si-Mn-Al from manganese-containing briquettes and high-ash coalsScientific Reports, 2024
- Effect of thermal treatment of chromium iron melts on the structure and properties of castingsMaterials Research Express, 2023
- Effect of thermomechanical processing of building stainless wire to increase its durabilityCase Studies in Construction Materials, 2023
- Study of changes in microstructure and metal interface Cu/Al during bimetallic construction wire strainingCase Studies in Construction Materials, 2023
- ICROSTRUCTURE EVOLUTION OF STEEL-ALUMINUM WIRE DURING DEFORMATION BY "EQUAL-CHANNEL ANGULAR PRESSING-DRAWING"METHODEurasian Physical Technical Journal, 2022
- PHASE TRANSFORMATIONS IN FERRITES DURING RADIATION-THERMAL SINTERINGEurasian Physical Technical Journal, 2020
- An experimental investigation of casing effect on mechanical properties of billet in ECAP processThe International Journal of Advanced Manufacturing Technology, 2016
- Using high-pressure torsion to process an aluminum–magnesium nanocomposite through diffusion bondingJournal of Materials Research, 2015
- The line Coating Robot - an automated mobile System for high Precision Powder CoatingIFAC-PapersOnLine, 2015