Tracking Microstructure Evolution in Complex Biaxial Strain Paths: A Bulge Test Methodology for the Scanning Electron Microscope
- 20 August 2019
- journal article
- research article
- Published by Springer Nature in Experimental Mechanics
- Vol. 60 (1) , 35-50
Abstract
No abstract availableKeywords
This publication has 69 references indexed in Scilit:
- High temperature composite forming limit diagrams of four magnesium AZ31B sheets obtained by pneumatic stretchingJournal of Materials Processing Technology, 2012
- Ductile fracture: Experiments and computationsInternational Journal of Plasticity, 2011
- A method for accurate localisation of EBSD pattern centresUltramicroscopy, 2011
- The role of heterogeneous deformation on damage nucleation at grain boundaries in single phase metalsInternational Journal of Plasticity, 2009
- Thin‐Film Characterization Using the Bulge Test2007
- Transformation Behavior of Retained Austenite in Hydroformed TRIP SteelMaterials Science Forum, 2002
- Modeling stress state dependent damage evolution in a cast Al–Si–Mg aluminum alloyTheoretical and Applied Fracture Mechanics, 2000
- Investigation on deformation mode dependence of strain-induced martensitic transformation in trip steels and modelling of transformation kineticsInternational Journal of Mechanical Sciences, 1998
- Sheet orientation and forming limits under diffuse neckingApplied Mathematical Modelling, 1996
- Experimental characterization of the local strain field in a heterogeneous elastoplastic materialActa Metallurgica et Materialia, 1994