Simulation and on-line monitoring using optical fiber Bragg grating sensors of temperature history during laser-assisted automated fiber placement
- 31 May 2024
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 58 (18) , 2079-2092
Abstract
Automated fiber placement (AFP) in situ consolidation (ISC) of thermoplastic composite possess the potential to reduce manufacturing costs and improve manufacturing efficiency. The properties of composite manufactured by the ISC are affected by several mechanisms including polymer degradation, crystallization, intimate contact, polymer healing and void dynamics. All these mechanisms are directly affected by the temperature history. Consequently, the control and accurate measurement of temperature history during ISC are particularly important for improving the properties of composite. In this study, a simplified three-dimensional transient heat transfer model was established. The effect of tool temperature and placement speed on the temperature history and peak temperature were predicted. Simultaneously, an online temperature monitoring system was built and the optical Fiber Bragg Grating sensors (FBGS) was used to measure the temperature history. The results indicated that the predicted results of the model were consistent with the measured results, the error was below 8%. In addition, the temperature history of layers was significantly affected by the tool temperature and placement speed. The temperature of the layers decreased to near the tool temperature after cooling, and a higher tool temperature increasing its peak temperature because of the reduce of the cooling rate. On the contrary, an increase in placement speed will reduce the peak temperature of the layers.Keywords
Funding Information
- National Key R&D Program of China (2022YFB3704503)
- National Key R&D Program of China (2022YFB3709204)
- Study on Auto Fiber Placement Technology of Thermoplastic Prepreg for Advanced Composite Skins
- Donghua University and Shanghai High Performance Fibers and Composites Center (Province-Ministry Joint), Donghua University
This publication has 30 references indexed in Scilit:
- Process modelling of In-situ consolidated thermoplastic composite by automated fibre placement – A reviewComposites Part A: Applied Science and Manufacturing, 2022
- Nanomechanical characterisation of CF-PEEK composites manufactured using automated fibre placement (AFP)Composites Communications, 2022
- On the temperature evolution during continuous laser-assisted tape winding of multiple C/PEEK layers: The effect of roller deformationInternational Journal of Material Forming, 2020
- Analysis and improved process response prediction of laser- assisted automated tape placement with PA-6/carbon tapes using Design of Experiments and numerical simulationsComposites Part A: Applied Science and Manufacturing, 2017
- A combined optical-thermal model for near-infrared laser heating of thermoplastic composites in an automated tape placement processComposites Part A: Applied Science and Manufacturing, 2015
- Mechanical characterisation of carbon fibre–PEEK manufactured by laser-assisted automated-tape-placement and autoclaveComposites Part A: Applied Science and Manufacturing, 2015
- The effects of heat input on adjacent paths during Automated Fibre PlacementComposites Part A: Applied Science and Manufacturing, 2015
- Fracture toughness of carbon fiber/polyether ether ketone composites manufactured by autoclave and laser‐assisted automated tape placementJournal of Applied Polymer Science, 2014
- Optimization of the tape placement process parameters for carbon–PPS compositesComposites Part A: Applied Science and Manufacturing, 2013
- Thermal modelling of tape laying with continuous carbon fibre-reinforced thermoplasticComposites, 1988