Integrating Finite Element Simulation with Actual GTAW Weld Profiles to Optimize Root Height in Stainless Steel 316L Pipe Joints
Open Access
Abstract
Weld root reinforcement is a critical geometric parameter governing stress concentration and structural performance in thin-walled stainless-steel piping systems designed to ASME B31.3. While current codes specify permissible dimensional limits, they do not explicitly quantify how incremental variations in root height influence stress distribution under realistic service loading conditions. This study integrates finite element analysis (FEA) with experimentally validated GTAW weld profiles to evaluate the structural influence of weld root height in 316L stainless-steel pipe joints. An experimentally manufactured 4 in schedule 10S joint with a measured root height of less than 1.5 mm was adopted as the baseline geometry. Additional models with reinforcement heights of 1.138, 2.0, 2.5, and 3.0 mm were evaluated under two representative load cases: (i) internal pressure combined with drag and axial thrust (LC-1), and (ii) internal pressure with thrust only (LC-2). The results demonstrate that reinforcement heights exceeding 2.0 mm increase von Mises, hoop, longitudinal, and radial stress gradients, with peak stresses shifting toward the weld toe under drag-inclusive loading. In contrast, reinforcement ≤2 mm provides smoother load transfer and reduced stiffness discontinuity across the weld interface. The combined numerical and experimental findings support a stress-informed upper limit of 2 mm for weld root reinforcement in thin-walled stainless-steel pipelines, offering a performance-based complement to existing dimensional acceptance criteria.Keywords
This publication has 27 references indexed in Scilit:
- Fatigue experiment and assessment of butt-welded joints in steel structures considering misalignment and weld geometry effectsInternational Journal of Fatigue, 2024
- Analysis and mitigation of the bending deformation in girth-welded slender pipes with numerical modelling and experimental measurementJournal of Manufacturing Processes, 2022
- 3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipelineJournal of Manufacturing Processes, 2021
- A robust stress analysis method for fatigue life prediction of welded structuresWelding in the World, 2016
- FEM prediction of welding residual stresses in a SUS304 girth-welded pipe with emphasis on stress distribution near weld start/end locationComputational Materials Science, 2010
- Stress concentrations due to misalignment at butt welds in plated structures and at girth welds in tubularsInternational Journal of Fatigue, 2009
- Stress concentrations at butt welds in pipelinesMarine Structures, 2009
- Stress concentration factors at welds in pipelines and tanks subjected to internal pressure and axial forceMarine Structures, 2008
- Fatigue strength of steel and aluminium welded joints based on generalised stress intensity factors and local strain energy valuesInternational Journal of Fracture, 2005
- Finite element methods for structural hot spot stress determination—a comparison of proceduresInternational Journal of Fatigue, 2004