Non-Contact MEMS-Sensor Array Inspection of Composites and Metallic Parts Using Lamb Waves
Open Access
- 2 March 2023
- journal article
- research article
- Published by ASME International in Journal of Nondestructive Evaluation, Diagnostics and Prognostics of Engineering Systems
- Vol. 6 (4) , 1-22
Abstract
Composite materials are becoming more popular in the aerospace industry, because of their physical properties. In quality assurance and in-service inspection, there is a need for fast, non-contact, high-quality, non-destructive inspection techniques. The most common approach is to perform the inspection using water-coupled high-frequency transducers. Full wavefield techniques are promising to replace the conventional inspection approach. However, these are currently performed by a laser vibrometer setup, which has drawbacks. As an alternative, a low-cost micro-electro-mechanical system (MEMS) sensor array and dedicated processing scheme are presented enabling fast inspection of large samples. This inspection approach uses a piezoelectric actuator to excite the composite or metallic part with Lamb waves. An array of MEMS sensors records the energy that radiates into the surrounding air. A dedicated processing scheme will translate the measured wavefield into a thickness map of the inspected part. For composite parts, the material’s anisotropy needs to be taken into account for accurate thickness mapping. In principle, all relevant defects show up as local thickness reductions. The results in this paper are obtained with a MEMS-sensor array of 128 elements capable of detecting ultrasound up to 250 kHz at a typical stand-off distance of 100 mm. Defects up to 6 mm in diameter could be detected in thick panels, and defects as small as 2.5 mm could be detected in thin panels. A full-size fuselage experiment shows that the method is also suited for fast inspection of large inspection areas.Keywords
Funding Information
- Horizon 2020 (958303)
This publication has 15 references indexed in Scilit:
- A review of non-destructive testing methods of composite materialsProcedia Structural Integrity, 2016
- Derivation and experimental validation of Lamb wave equations for an n-layered anisotropic composite laminateComposite Structures, 2014
- Structural imaging through local wavenumber estimation of guided wavesNDT & E International, 2013
- Laser ultrasonic anomalous wave propagation imaging method with adjacent wave subtraction: AlgorithmOptics & Laser Technology, 2012
- Piezoelectric MEMS sensors: state-of-the-art and perspectivesMeasurement Science and Technology, 2009
- Structural health monitoring using scanning laser vibrometry: III. Lamb waves for fatigue crack detectionSmart Materials and Structures, 2005
- The mechanical behavior of GLARE laminates for aircraft structuresJOM, 2005
- Structural health monitoring using scanning laser vibrometry: I. Lamb wave sensingSmart Materials and Structures, 2004
- Finite-difference modeling of viscoelastic and anisotropic wave propagation using the rotated staggered gridGeophysics, 2004
- Delamination—a damage mode in composite structuresEngineering Fracture Mechanics, 1988