Sectioning of multilayers to make a multilayer Laue lens
- 1 April 2007
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 78 (4) , 046103
Abstract
We report a process to fabricate multilayer Laue lenses (MLL’s) by sectioning and thinning multilayer films. This method can produce a linear zone plate structure with a very large ratio of zone depth to width (e.g., ), orders of magnitude larger than can be attained with photolithography. Consequently, MLL’s are advantageous for efficient nanofocusing of hard x rays. MLL structures prepared by the technique reported here have been tested at an x-ray energy of , and a diffraction-limited performance was observed. The present article reports the fabrication techniques that were used to make the MLL’s.
Keywords
This publication has 8 references indexed in Scilit:
- A multilayer nanostructure for linear zone-plate applicationsThin Solid Films, 2006
- Nanometer Linear Focusing of Hard X Rays by a Multilayer Laue LensPhysical Review Letters, 2006
- Depth-graded multilayers for application in transmission geometry as linear zone platesJournal of Applied Physics, 2005
- Soft X-ray microscopy at a spatial resolution better than 15 nmNature, 2005
- High-efficiency diffractive x-ray optics from sectioned multilayersApplied Physics Letters, 2005
- Multilayer Laue lenses as high-resolution x-ray optics2004
- Nanometer focusing of hard x rays by phase zone platesReview of Scientific Instruments, 1999
- Cross-section TEM sample preparation of multilayer and poorly adhering filmsMicroscopy Research and Technique, 1997