Impact-Ionization Switching of High-Voltage Thyristors Connected in Parallel
- 26 May 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 51 (10) , 2878-2884
Abstract
Thyristors triggered in the impact-ionization wave mode is a promising switching method in pulsed power technology. This triggering approach enhances the current capability of standard thyristors, allowing switching a current pulse with an amplitude of 200 kA and a current rise time rate-of-change (dI/dt) of 58 kA/ $\mu$ s. Thyristor wafer area can be considered as one of the factors that are limiting the peak current amplitude and dI/dt. Switching thyristors in parallel is a possible solution to overcome these limitations. However, no evidence was found in the literature for successful parallel switching of standard thyristors in the impact-ionization wave mode. In this research, the possibility of parallel switching of two standard thyristors rated for 2.2 kV with a wafer diameter of 32 mm was investigated. A Marx generator equipped with a peaking module was used to charge the thyristor equivalent capacitance (1 nF) up to double its static breakdown voltage with a voltage rise time rate-of-change (dV/dt) of more than 1 kV/ns, as required for impact-ionization triggering. The diagnostic system includes two wideband voltage probes (VPs) with a subnanosecond time response, which allows simultaneous measurement of a voltage drop across each thyristor connected in parallel. Two stages of thyristor operation were investigated: 1) a triggering stage, without energy switching, when a dc bias voltage is applied; and 2) a current flow stage, with energy switching, when an $RLC$ discharge circuit is connected. In these experiments, thyristors change from blocking to conducting state within 400 ps, switching a current pulse with an amplitude of 11 kA and a dI/dt of 6 kA/ $\mu$ s (circuit limits). The current imbalance between the thyristors was less than 10%. To the best of the authors’ knowledge, it is the first time reported that high-voltage thyristors connected in parallel have been successfully triggered in the impact-ionization wave mode.Keywords
Funding Information
- Framework of E2S Université de Pau et des Pays de 1’Adour (UPPA) (S2P2 Chair and Pulsed Power Applications
- “Investissements d’Avenir,” a French Program managed by the Agence nationale de la recherche (ANR-16-IDEX-0002)
This publication has 19 references indexed in Scilit:
- Superfast Thyristor-Based Switches Operating in Impact-Ionization Wave ModeIEEE Transactions on Plasma Science, 2016
- High power thyristors triggering providing a subnanosecond closing time2014
- High-power switches based on reversely switched-on dynistors for high-voltage pulse technologiesInstruments and Experimental Techniques, 2014
- Energy Spectrum Measurement of X-Ray Radiation From a Compact X-Pinch DeviceIEEE Transactions on Plasma Science, 2014
- A 12-kV High-Voltage Semiconductor Switch Based on 76-mm Reverse-Switching DynistorsIEEE Transactions on Plasma Science, 2010
- The Science and Technologies for Fusion Energy With Lasers and Direct-Drive TargetsIEEE Transactions on Plasma Science, 2010
- A High-Current High-$di/dt$ Pulse Generator Based on Reverse Switching DynistorsIEEE Transactions on Plasma Science, 2009
- Pulsed power application assisted by power semiconductor devices2002
- Reverse switching dynistor pulsersIEEE Transactions on Plasma Science, 2000
- Theory of quasi-diode operation of reversely switched dinistorsSolid-State Electronics, 1988