A Study on the Propagation Characteristics of Partial Discharge in Cable Joints Based on the FDTD Method
Authors:
Open Access
- 15 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 130094-130103
Abstract
Partial discharge (PD) is the main cause of cable insulation deterioration. It is of great theoretical significance and practical value to carry out PD research on high voltage (HV) cable joints for fault detection and operational status evaluation. In this paper, a three-dimensional finite-difference time-domain (FDTD) simulation model of cable joint is built. According to typical fault types of PD in 110kV XLPE cable, four types of insulation defect models, including electrical tree discharge, surface sliding discharge, air gap discharge, and floating discharge, are designed and manufactured. Based on the three-dimensional simulation model of cable joint, the propagation characteristics of PD signals caused by the aforementioned insulation defects are analyzed, the effects of different types of insulation defects and fault locations on the propagation characteristics are investigated. A PD experimental platform based on a cross-bonded three-phase 110 kV cross-linked polyethylene (XLPE) cable system is built for verifying the feasibility of the three-dimensional simulation model. Results show that the model can reasonably explain propagation characteristics of PD signals in cable joints, including polarity, peak values, attenuation characteristics and symmetry, which provided the theoretical basis for judging the fault locations and types of PD caused by insulation defects in cable joints.Keywords
Funding Information
- National Natural Science Foundation of China (50777020)
This publication has 20 references indexed in Scilit:
- A Technique for Representing Coaxial Cables for FDTD-Based Surge SimulationsIEEE Transactions on Electromagnetic Compatibility, 2015
- On-line PD detection and localization in cross-bonded HV cable systemsIEEE Transactions on Dielectrics and Electrical Insulation, 2014
- Three‐Dimensional Simulation2013
- Extraction of high frequency power cable characteristics from S-parameter measurementsIEEE Transactions on Dielectrics and Electrical Insulation, 2004
- Comparison of on-line partial discharge detection methods for HV cable jointsIEEE Transactions on Dielectrics and Electrical Insulation, 2002
- Full-wave analysis of shielded cable configurations by the FDTD methodIEEE Transactions on Magnetics, 2002
- On-site partial discharge measurements on premoulded cross-bonding joints of 170 kV XLPE and EPR cablesIEEE Transactions on Power Delivery, 1998
- Three-Dimensional Perfectly Matched Layer for the Absorption of Electromagnetic WavesJournal of Computational Physics, 1996
- Study on detection for the defects of XLPE cable linesIEEE Transactions on Power Delivery, 1996
- Numerical solution of initial boundary value problems involving maxwell's equations in isotropic mediaIEEE Transactions on Antennas and Propagation, 1966