Liquid film behavior upon an oblique jet impinging on a solid wall
- 1 March 2025
- journal article
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (3)
Abstract
This work numerically explores the effect of different Reynolds numbers, inclination angles, and wall surface roughness on liquid film behaviors upon a jet impinging on a solid wall. The Volume of Fluid approach with contact angle correction, in conjunction with surface roughness estimation based on boundary layer flow, was applied. A new model for predicting the geometry of the liquid film with full consideration of flow characteristics and jet conditions was proposed. Results show that the present model predicts the maximum liquid film width, the starting point of the liquid film, and the liquid film morphology with improved accuracy. With an increase in jet Reynolds number from 1600 to 3600, the maximum width of the liquid film increases from r/D = 11.8 to 16.5, and the maximum thickness increases from h/D = 1.2 to 1.9. The pressure coefficient shows little change, while the skin friction coefficient decreases with higher Reynolds number. The variation of α from 45° to 75° shows a weak influence on the film thickness distribution in the thin layer zone. Increasing the injection angle results in a downward shift (r/D = 0.8) of the maximum pressure coefficient. The maximum pressure coefficient increases by about 25%, while the maximum skin friction coefficient increases by about 55% with a higher injection angle. With an increase in surface roughness, the maximum width of the liquid film increases about 10%, the maximum pressure coefficient by about 20%, and the maximum skin friction coefficient by about 26%.Keywords
Funding Information
- National Natural Science Foundation of China (52236001)
- National Natural Science Foundation of China (91941101)
This publication has 35 references indexed in Scilit:
- Thermal state calculation of chamber in small thrust liquid rocket engine for steady state pulsed modeChinese Journal of Aeronautics, 2019
- Semi-empirical model for the engine liquid fuel sheet formed by the oblique jet impinging onto a plateFuel, 2018
- Numerical study of turbulent annular impinging jet flow and heat transfer from a flat surfaceApplied Thermal Engineering, 2018
- Positron Emission Particle Tracking (PEPT) for the analysis of water motion in a domestic dishwasherChemical Engineering Journal, 2015
- Flow patterns and draining films created by horizontal and inclined coherent water jets impinging on vertical wallsChemical Engineering Science, 2013
- A new generalised model for liquid film cooling in rocket combustion chambersInternational Journal of Heat and Mass Transfer, 2012
- Surface flow and drainage films created by horizontal impinging liquid jetsChemical Engineering Science, 2012
- A continuum method for modeling surface tensionJournal of Computational Physics, 1992
- Volume of fluid (VOF) method for the dynamics of free boundariesJournal of Computational Physics, 1981
- Impingement of an axisymmetric liquid jet on a barrierInternational Journal of Heat and Mass Transfer, 1978