Effect of Chromium Carbide on the Structure of a Sprayed Metal upon Its Introduction into the Composition of a Filler Flux-Cored Wire Charge
Authors:
- 1 December 2022
- journal article
- research article
- Published by Pleiades Publishing Ltd in Russian Metallurgy (Metally)
- Vol. 2022 (13) , 1836-1841
Abstract
—A scheme of arc spraying with a flux-cored wire in a protecting gas atmosphere using a filler flux-cored wire is considered. In this scheme, a filler wire is fed from the side of the tail part of the welding bath. The filler flux-cored wire charges contain chromium carbide. Chromium carbide is shown to decompose during spraying, which leads to alloying of the sprayed metal with chromium and carbon. The use of chromium carbide is found to increase the coefficient of transition of carbon and chromium into the sprayed metal. When ferrochrome is completely replaced with chromium carbide, needlelike chromium carbide forms in the sprayed metal.Keywords
This publication has 5 references indexed in Scilit:
- Chromium Carbides in Abrasion-Resistant CoatingsRussian Engineering Research, 2020
- Abrasive wear of V–Nb–Ti alloyed high-chromium white ironsWear, 2015
- Influence of welding parameters on microstructure and wear behaviour of a typical NiCrBSi hardfacing alloy reinforced with tungsten carbideSurface and Coatings Technology, 2008
- Microstructure and abrasive wear behaviour of shielded metal arc welding hardfacings used in the sugarcane industryWear, 2007
- The effect of microstructure on abrasive wear of hardfacing alloysWear, 2005