Combined Effects of Wakes and Jet Pulsing on Film Cooling
Authors:
- 1 August 2008
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 130 (4) , 041010
Abstract
Pulsed film cooling jets subject to periodic wakes were studied experimentally. The wakes were generated with a spoked wheel upstream of a flat plate. Cases with a single row of cylindrical film cooling holes inclined at 35deg to the surface were considered at blowing ratios B of 0.50 and 1.0 with jet pulsing and wake Strouhal numbers of 0.15, 0.30, and 0.60. Wake timing was varied with respect to the pulsing. Temperature measurements were made using an infrared camera, thermocouples, and constant current (cold wire) anemometry. The local film cooling effectiveness and heat transfer coefficient were determined from the measured temperatures. Phase locked flow temperature fields were determined from cold-wire surveys. With B=0.5, wakes and pulsing both lead to a reduction in film cooling effectiveness, and the reduction is larger when wakes and pulsing are combined. With B=1.0, pulsing again causes a reduction in effectiveness, but wakes tend to counteract this effect somewhat by reducing jet lift-off. At low Strouhal numbers, wake timing had a significant effect on the instantaneous film cooling effectiveness, but wakes in general had very little effect on the time averaged effectiveness. At high Strouhal numbers, the wake effect was stronger, but the wake timing was less important. Wakes increased the heat transfer coefficient strongly and similarly in cases with and without film cooling, regardless of wake timing. Heat transfer coefficient ratios, similar to the time averaged film cooling effectiveness, did not depend strongly on wake timing for the cases considered.Keywords
This publication has 28 references indexed in Scilit:
- Effect of Jet Pulsing on Film Cooling—Part I: Effectiveness and Flow-Field Temperature ResultsJournal of Turbomachinery, 2006
- Effect of Jet Pulsing on Film Cooling—Part II: Heat Transfer ResultsJournal of Turbomachinery, 2006
- Effect of Jet Pulsation and Duty Cycle on Film Cooling From a Single Jet on a Leading Edge ModelJournal of Turbomachinery, 2006
- Effects of Bulk Flow Pulsations on Film Cooling With Compound Angle Holes: Heat Transfer Coefficient Ratio and Heat Flux RatioJournal of Turbomachinery, 2001
- Unsteady Wake Effect on Film Temperature and Effectiveness Distributions for a Gas Turbine BladeJournal of Turbomachinery, 1999
- Effect of Periodic Wake Passing on Film Effectiveness of Inclined Discrete Cooling Holes Around the Leading Edge of a Blunt BodyJournal of Turbomachinery, 1998
- Combined Effect of Grid Turbulence and Unsteady Wake on Film Effectiveness and Heat Transfer Coefficient of a Gas Turbine Blade With Air and CO2 Film InjectionJournal of Turbomachinery, 1997
- An Experimental Study of the Effect of Wake Passing on Turbine Blade Film CoolingJournal of Turbomachinery, 1997
- Bulk flow pulsations and film cooling—I. Injectant behaviorInternational Journal of Heat and Mass Transfer, 1996
- Unsteady Boundary Layers on a Flat Plate Disturbed by Periodic Wakes: Part I—Measurement of Wake-Affected Heat Transfer and Wake-Induced Transition ModelJournal of Turbomachinery, 1996