Investigation of Spectral Properties, Thermal Stability, and Morphology in Polyaniline Doped with Chlorocarboxylic Acids
Authors:
- 1 July 2006
- journal article
- research article
- Published by Taylor & Francis in International Journal of Polymer Analysis and Characterization
- Vol. 11 (3) , 239-252
Abstract
The morphology of polyaniline (PANI), granular or tubular, depends on the acidity conditions during the reaction rather than on the chemical nature of the acid. In reference to acetic acid in which media nanotubes had been observed, dichloroacetic acid (DCA) and trichloroacetic acid (TCA) were used to synthesize polyaniline by the oxidative polymerization technique. Characterization by Fourier-transform infrared (FTIR), UV-visible, and electron paramagnetic (EPR) spectroscopy techniques indicated that the polymers are in the protonated emeraldine form and suggest that the protonation of PANI in media containing such acids was achieved with the help of sulfuric acid produced during the reaction from ammonium peroxydisulfate. The conductivity of polyaniline prepared in DCA was 0.04 S cm−1 and 0.5 S cm−1 in TCA. The thermal stability of polyaniline salts was tested by thermogravimetric analysis and a three-step decomposition pattern was observed. Wide-angle X-ray diffraction (WAXD) study showed enhanced crystallinity in polyaniline prepared in TCA. The morphology is discussed in relation to the formation of polyaniline nanotubes reported in the literature.Keywords
This publication has 36 references indexed in Scilit:
- A General Chemical Route to Polyaniline NanofibersJournal of the American Chemical Society, 2003
- Synthesis and characterization of polyaniline prepared in formic acid mediumJournal of Applied Polymer Science, 2003
- Comparison of Emeraldine Salt, Emeraldine Base, and Epoxy Coatings for Corrosion Protection of Steel During Immersion in a Saline SolutionCorrosion, 2003
- Polyaniline. Preparation of a conducting polymer(IUPAC Technical Report)Pure and Applied Chemistry, 2002
- Electrical and mechanical properties of polyaniline fibres produced by a one-step wet spinning processPolymer, 2000
- Highly Conducting and Solution-Processable Polyaniline Obtained via Protonation with a New Sulfonic Acid Containing Plasticizing Functional GroupsMacromolecules, 2000
- In-situ polymerized polyaniline filmsSynthetic Metals, 1999
- Polyaniline with surfactant counterions: Conducting polymer materials which are processible in the conducting formSynthetic Metals, 1993
- Thermal stabilities of polyanilinesSynthetic Metals, 1991
- X-ray structure of polyanilineMacromolecules, 1991