Power transfer using portable surfaces in capacitively coupled power transfer technology
Open Access
- 1 April 2016
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 9 (5) , 997-1008
Abstract
Capacitively coupled power transfer (CCPT) uses electrostatic mechanism to deliver power from a stationary transmitter to a mobile receiver. The authors study various aspects of this technology including physical limitations that are encountered to increase power transfer. They characterise the impact of input voltage, dielectric area, and permittivity of the dielectric material in realisation of CCPT system. It is observed that the peak voltage and VA ratings of the capacitors are affected by the choice of the aforementioned parameters. Air as a dielectric medium leads to low power density. A high permittivity material instead of air dielectric can be used to improve power density. This strategy will make the CCPT technology non‐contactless, because a physical contact exists between the transmitter and receiver. However, this contact is different from an ohmic contact. A high power density CCPT system is realised using ceramic dielectric surfaces. Issues encountered in system realization are discussed including automatic resonant frequency tracking. Detailed mathematical models under resonance and off‐resonance operation are proposed. The models are validated using simulations and experimental results. A low cost multilayer ceramic capacitor (MLCC) based high power‐density transfer surface is realised. Results show that 35 W can be easily transferred using a set of 12 mm 2 capacitive surfaces and 32 V source.Keywords
This publication has 13 references indexed in Scilit:
- A Survey of Wireless Power Transfer and a Critical Comparison of Inductive and Capacitive Coupling for Small Gap ApplicationsIEEE Transactions on Power Electronics, 2015
- Overview of wireless power transfer technologies for electric vehicle battery chargingIET Power Electronics, 2014
- Design of a zero‐voltage‐switching large‐air‐gap wireless charger with low electric stress for electric vehiclesIET Power Electronics, 2013
- Unplugged But Connected: Review of Contactless Energy Transfer SystemsIEEE Industrial Electronics Magazine, 2012
- Modular-based inductive power transfer system for high-power applicationsIET Power Electronics, 2012
- Effective Capacitive Power TransferIEEE Transactions on Power Electronics, 2012
- Modelling and analysis of a capacitively coupled contactless power transfer systemIET Power Electronics, 2011
- Capacitive power transfer for contactless charging2011
- Capacitive Inter-Chip Data and Power Transfer for 3-D VLSIIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 2006
- Fundamentals of Power Electronics2001