Flow‐induced fiber orientation in injection molded fit fiber reinforced polypropylene
Authors:
- 1 October 2001
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 22 (5) , 680-689
Abstract
A through experimental study of flax fiber orientation in a plate processed by injection molding is presented. The state of orientation is described by oriental tensors and partly by frequency distribution diagrams. Composite stiffness is predieted by use of a modified classical laminate theory including unidirectional mels and orientation averaging. Comparison of the measured and calculated modulus in tension shows good agreement.Keywords
This publication has 11 references indexed in Scilit:
- Thermogravimetric and differential scanning calorimetric analysis of natural fibres and polypropyleneThermochimica Acta, 1999
- On the effect of the fiber orientation on the flexural stiffness of injection molded short fiber reinforced polycarbonate platesPolymer Composites, 1998
- Polypropylene-wood fiber composites: Effect of treatment and mixing conditions on mechanical propertiesJournal of Applied Polymer Science, 1997
- Biofiber‐reinforced polypropylene compositesPolymer Engineering & Science, 1997
- An experimental study of fibre orientation in injection moulded short glass fibre-reinforced polypropylene/polyarylamide compositesComposites, 1994
- Fiber orientation and mechanical properties of short‐fiber‐reinforced injection‐molded composites: Simulated and experimental resultsPolymer Composites, 1993
- Some studies on glass fiber‐reinforced polypropylene. Part I: Reduction in fiber length during processingPolymer Composites, 1989
- The Use of Tensors to Describe and Predict Fiber Orientation in Short Fiber CompositesJournal of Rheology, 1987
- Phase separation effects in processing of glass‐bead‐ and glass‐fiber‐filled thermoplastics by injection moldingPolymer Engineering & Science, 1985
- The Halpin‐Tsai equations: A reviewPolymer Engineering & Science, 1976