A novel die to wafer (D2W) collective bonding method for MEMS and electronics heterogeneous 3D integration
Authors:
- 1 June 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 05695503,p. 829-833
Abstract
A new D2W collective bonding approach is demonstrated with functional MEMS devices with smaller than 3 × 3 mm 2 and 8 inch ASIC wafers. The new package design was proposed in order to reduce the parasitic effect by attaching the released MEMS dice directly to the pads on an ASIC wafer. Two different types of MEMS devices having combs structure and a beam structure were used in order to confirm the minimal change in the MEMS functionality before and after D2W bonding. The ASIC wafer consisted of non functional circuit with pads and the daisy chain for measuring the electrical resistance and interconnection lead-out. With the new method by utilizing both the standard pick and place machine and the wafer bonder, ~ 800 numbers of functional MEMS dice were bonded to ASIC by low temperature D2W collective bonding at 200 degC for 2 minutes having an alignment tolerance less than 10% in 150 μm pitch with pad size of 75 μm. In this approach, the bonding time has been reduced by more than 50% in comparison with the conventional D2W bonding with flip chip bonder and performance of the package was improved by direct interconnection and the yield was improved by bonding with Known Good Dice.Keywords
This publication has 4 references indexed in Scilit:
- Development of novel intermetallic joints using thin film indium based solder by low temperature bonding technology for 3D IC stacking2009
- A Low-Power Oven-Controlled Vacuum Package Technology for High-Performance MEMS2009
- A novel, wafer-level stacking method for low-chip yield and non-uniform, chip-size wafers for MEMS and 3D SIP applications2008
- A Vertical Wafer Level Packaging using Through Hole Filled Via Interconnects by Lift Off Polymer Method for MEMS and 3D Stacking Applications2005