Modeling of the Thread Milling Operation in a Combined Thread/Drilling Operation: Thrilling
- 1 February 2010
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 132 (1) , 014505
Abstract
This paper investigates a thread making process called thrilling, which performs both drilling and thread milling with one tool. A chip thickness and mechanistic cutting force model has been developed for a thread milling operation with a thrilling tool. The model considers the complex geometry of a thrilling tool and the unique tool paths associated with the thread milling operation. Experiments have been conducted to validate the developed model. Comparison of the average torque and forces between experiment and simulation results shows that the model predicts the experimental results within 12% error.Keywords
This publication has 11 references indexed in Scilit:
- Modeling and Analysis of the Thread Milling Operation in the Combined Drilling/Thread Milling Process2008
- A model for thread milling cutting forcesInternational Journal of Machine Tools and Manufacture, 2006
- Influence of Parameters of the Cutting Part of Taps on Threading AccuracyMeasurement Techniques, 2005
- Dynamics of Initial Penetration in Drilling: Part 1—Mechanistic Model for Dynamic ForcesJournal of Manufacturing Science and Engineering, 2005
- Experimental Investigation of Thread Formation in Form TappingJournal of Manufacturing Science and Engineering, 2005
- An analytical finite element technique for predicting thrust force and torque in drillingInternational Journal of Machine Tools and Manufacture, 2004
- Chatter Stability of Metal Cutting and GrindingCIRP Annals, 2004
- Investigation of thread tapping load characteristics through mechanistics modeling and experimentationInternational Journal of Machine Tools and Manufacture, 2002
- Mechanistic Model for Tapping Process With Emphasis on Process Faults and Hole GeometryJournal of Manufacturing Science and Engineering, 2001
- A Mechanistic Model to Predict the Cutting Force System for Arbitrary Drill Point GeometryJournal of Manufacturing Science and Engineering, 1998