Simultaneous in-situ measurement of pressure-dependent bulk and interfacial thermal properties in thermal interface materials
Preprint
- 18 April 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Thermal interface materials (TIMs) critically govern heat transfer between chips and heat spreaders, yet under practical assembly pressures, their thermal conductivity (k), volumetric heat capacity (C), and interfacial thermal resistance (ITR) co-evolve in ways that existing steady-state and transient methods cannot simultaneously resolve. Here, we extend square-pulsed source (SPS) thermoreflectance to a pressure-controlled platform, enabling simultaneous, in-situ extraction of k, C, and ITR in compressed TIM stacks from a single measurement. By spanning modulation frequencies from 1 Hz to 10 MHz, SPS accesses thermal penetration depths that distinguish bulk heat diffusion/storage from interfacial heat transfer. Measurements on a thermally conductive gel, a thermal pad, and a high-vacuum grease during compression-unloading cycles reveal distinct pressure- and history-dependent behaviors. The gel and pad show increasing k and C, decreasing ITR, and pronounced hysteresis, consistent with coupled bulk densification and interfacial evolution, whereas the grease displays pressure-invariant bulk properties but interface-dominated resistance reduction. Validated against poroelastic and contact-mechanics models, these findings establish a framework for state-aware thermal design in advanced electronic packaging.Keywords
This publication has 22 references indexed in Scilit:
- Advancing Thermal Management Technology for Power Semiconductors through Materials and Interface EngineeringAccounts of Materials Research, 2025
- Performance of Thermal Interface MaterialsSmall, 2022
- Modeling of pvT behavior of semi-crystalline polymer based on the two-domain Tait equation of state for injection moldingMaterials & Design, 2019
- Thermal Conductivity of Thermal Interface Materials Evaluated By a Transient Plane Source MethodJournal of Electronic Materials, 2019
- Measurement of thermal interface conductance at variable clamping pressures using a steady state methodApplied Thermal Engineering, 2016
- An improved model for predicting thermal contact resistance at liquid–solid interfaceInternational Journal of Heat and Mass Transfer, 2015
- A predictive model for the thermal contact resistance at liquid–solid interfaces: Analytical developments and validationInternational Journal of Thermal Sciences, 2011
- Heat Capacity2008
- Thermal characterization of Al2O3 and ZnO reinforced silicone rubber as thermal pads for heat dissipation purposesThermochimica Acta, 2005
- Thermal contact conductanceInternational Journal of Heat and Mass Transfer, 1969