Microstructure and mechanical properties of aluminium/steel dissimilar weldments: effect of heat input
- 30 April 2016
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 33 (2) , 200-209
Abstract
Lap joints of aluminium alloy A6061-T6 and galvanised steel DP800 were produced by an advanced gas metal arc welding process with AlSi3Mn filler. Four heat inputs designated as A (110 J mm−1), B (120 J mm−1), C (130 J mm−1) and D (140 J mm−1) were used during the process and the joints made were subjected to analysis of the microstructures, mechanical properties, residual stresses and corrosion behaviour. Microstructural analysis shows the formation and variation of Fe–Al intermetallic (IM) layer. It is also found that the joints made using the heat input of 120 J mm−1 exhibited highest tensile strength and better corrosion resistance. Electron microscopy and X-ray diffraction analysis revealed the presence of different IM phases with other strengthening precipitates.Keywords
This publication has 27 references indexed in Scilit:
- Influence of intermetallic phases and Kirkendall-porosity on the mechanical properties of joints between steel and aluminium alloysMaterials Science and Engineering: A, 2011
- Comprehensive analysis of joint strength for dissimilar friction stir welds of mild steel to aluminum alloysScripta Materialia, 2009
- Spreading behavior and microstructure characteristics of dissimilar metals TIG welding–brazing of aluminum alloy to stainless steelMaterials Science and Engineering: A, 2009
- Electromagnetic impact welding of aluminum to stainless steel sheetsJournal of Materials Processing Technology, 2008
- Vacuum brazing technology and microstructure near the interface of Al/18-8 stainless steelMaterials Research Bulletin, 2003
- Diffusion bonding of aluminium oxide to stainless steel using stress relief interlayersMaterials Science and Engineering: A, 2002
- Ultrasonic butt welding of aluminum, aluminum alloy and stainless steel plate specimensUltrasonics, 2002
- Light-weight structures produced by laser beam joining for future applications in automobile and aerospace industryJournal of Materials Processing Technology, 2001
- Ultrasonic Butt Welding of Aluminum and Stainless Steel Specimens Using a 15 kHz Welding SystemJapanese Journal of Applied Physics, 1999
- Spot welding of aluminium and steel sheet with an insert of aluminium clad steel sheet: Dissimilar metal joining of aluminium and steel sheet (1st Report)Welding International, 1996