Lithium-ion battery performance enhanced by the combination of Si thin flake anodes and binary ionic liquid systems
Open Access
- 5 June 2020
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 1 (4) , 625-631
Abstract
The use of ionic liquid (IL)-based electrolytes is one of the methods for solving various problems that pertain to the large-capacity anodes, such as Si and Li, for next-generation lithium ion batteries (LIBs). There is insufficient information about the combinations of such anodes and the IL electrolytes. In the present study, Si thin flake, which is one of the promising Si anode active materials, and binary IL electrolytes, 83.3–16.7 mol% 1-ethyl-3-methylimidazolium bis((fluorosulfonyl)amide)) ([C2mim][FSA])–lithium bis(trifluoromethanesulfonyl)amide (Li[TFSA]), 83.3–16.7 mol% [C2mim][FSA]–lithium bis((fluorosulfonyl)amide)) (Li[FSA]), and 50.0–50.0 mol% [C2mim][FSA]–Li[FSA], were used for collecting various information on the battery performance, morphology variation of the Si thin flake, and chemical species in the solid electrolyte interface (SEI) layer. Operando scanning electron microscopy (SEM) and ex-situ X-ray photoelectron spectroscopy (XPS) revealed that the SEI layer composition depends on the Li salt species and that their molar fractions in the binary IL electrolytes strongly affect the morphology variation in the Si thin flakes during the charge process. When the favorable Li conductive components, e.g., LiF and Li3N, were abundantly contained in the SEI layer, the charge and discharge behavior of the Si thin flake anode was greatly improved. The best battery performance was obtained by the combination of the Si thin flake composite anode and the 50.0–50.0 mol% [C2mim][FSA]–Li[FSA]. Discharge capacity above 1100 mAh g−1 was achieved even after 500 cycles under the charge and discharge condition at 3 C rate.Keywords
Funding Information
- Advanced Low Carbon Technology Research and Development Program (JPMJAL1301)
- Japan Science and Technology Agency (JST-MIRAI program, grant number JPMJMI17E9)
This publication has 36 references indexed in Scilit:
- Performance and cost of materials for lithium-based rechargeable automotive batteriesNature Energy, 2018
- Morphology changes and long-term cycling durability of Si flake powder negative electrode for lithium-ion batteriesElectrochimica Acta, 2018
- In situ Scanning Electron Microscopy of Silicon Anode Reactions in Lithium-Ion Batteries during Charge/Discharge ProcessesScientific Reports, 2016
- Effects of Li pre-doping on charge/discharge properties of Si thin flakes as a negative electrode for Li-ion batteriesSolid State Ionics, 2014
- Influence of Li diffusion distance on the negative electrode properties of Si thin flakes for Li secondary batteriesSolid State Ionics, 2012
- Porous Doped Silicon Nanowires for Lithium Ion Battery Anode with Long Cycle LifeNano Letters, 2012
- Stable cycling of double-walled silicon nanotube battery anodes through solid–electrolyte interphase controlNature Nanotechnology, 2012
- Building better batteriesNature, 2008
- High-performance lithium battery anodes using silicon nanowiresNature Nanotechnology, 2007
- Highly Reversible Lithium Storage in Nanostructured SiliconElectrochemical and Solid-State Letters, 2003