On the Origin of Temperature Induced Performance Degradation of Cu-Contacted Mg2X-Based (X = Si, Sn) Thermoelectric Materials
Open Access
- 29 April 2025
- journal article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (19) , 28777-28788
Abstract
Mg2X (X = Si, Sn)-based solid solutions are promising candidates for mid-to-high temperature waste heat recovery, but developing long-term stable thermoelectric generators (TEG) remains challenging. While Mg2X demonstrates excellent thermoelectric performance, it is susceptible to Mg loss, causing changes in carrier concentration through the formation of intrinsic defects. More severe degradation has further been observed for samples following contacting with a metal electrode, presenting an additional challenge for TEG technology advancement. We propose atomic layer deposition (ALD) to first enhance the material stability by suppression of Mg sublimation and second to differentiate between the different degradation mechanisms occurring at high operating temperatures. Our primary results from integral electrical conductivity and Seebeck coefficient measurements on coated samples without a Cu electrode at 723 K show enhanced material stability, while spatially resolved interface characterization of samples with Cu electrodes indicate comparable degradation for both coated and uncoated samples. This confirms Mg-Cu interdiffusion as the primary degradation mechanism for contacted samples with a higher relevance than Mg sublimation. Finally, wavelength-dispersive spectroscopy is used to reveal that the observed reduction in the charge carrier concentration during contacting is primarily due to Mg diffusing into the Cu electrode, not by the diffusion of Cu into the TE material as speculated previously, making this study the first to experimentally demonstrate the relevance of Mg loss into the electrode. By combining ALD coating to inhibit Mg loss with microstructural analysis, we present a methodology to distinguish TE material/electrode-related degradation mechanisms, enabling future advancements in Mg2(Si, Sn)-based TEGs.Keywords
Funding Information
- Leibniz-Gemeinschaft
- Deutsche Forschungsgemeinschaft (396709363)
This publication has 48 references indexed in Scilit:
- Instability Mechanism in Thermoelectric Mg2(Si,Sn) and the Role of Mg Diffusion at Room TemperatureSmall Science, 2025
- Performance Degradation and Protective Effects of Atomic Layer Deposition for Mg‐based Thermoelectric ModulesAdvanced Functional Materials, 2024
- High‐Performance Thermoelectric Devices Made Faster: Interface Design from First Principles CalculationsAdvanced Physics Research, 2023
- Efficiency Measurement and Modeling of a High‐Performance Mg2(Si,Sn)‐Based Thermoelectric GeneratorAdvanced Engineering Materials, 2022
- Thermoelectric Generators: Alternative Power Supply for Wearable Electrocardiographic SystemsAdvanced Science, 2020
- Diffusion Kinetics in Mg-Cu Binary SystemJournal of Phase Equilibria and Diffusion, 2015
- Power-Generation Performance of a π-Structured Thermoelectric Module Containing Mg2Si and MnSi1.73Journal of Electronic Materials, 2015
- Methods for Enhancing the Thermal Durability of High-Temperature Thermoelectric MaterialsJournal of Electronic Materials, 2013
- High-Temperature Measurement of Seebeck Coefficient and Electrical ConductivityJournal of Electronic Materials, 2013
- Energy Harvesting Technologies2009