Radhika Deshpande
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Radhika Deshpande has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Johannes de Boor
German Aerospace Center (DLR)
5 shared publications Eckhard Mueller
Institute of Materials Research German Aerospace Center (DLR) D–51147 Cologne Germany
4 shared publications- Amandine Duparchy
Institute for Frontier Materials on Earth and in Space German Aerospace Center (DLR) 51147 Cologne Germany
3 shared publications - Aryan Sankhla
Institute of Materials Research German Aerospace Center (DLR) D–51147 Cologne Germany
2 shared publications - Byungki Ryu
Korea Electrotechnology Research Institute (KERI)
2 shared publications Eckhard Müller
Institute of Materials Research, German Aerospace Centre (DLR)
2 shared publications
Latest Publications
- Open Access
- 29 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (19) , 28777-28788
On the Origin of Temperature Induced Performance Degradation of Cu-Contacted Mg2X-Based (X = Si, Sn) Thermoelectric Materials
Mg2X (X = Si, Sn)-based solid solutions are promising candidates for mid-to-high temperature waste heat recovery, but developing long-term stable thermoelectric generators (TEG) remains challenging. While Mg2X demonstrates excellent thermoelectric performance, it is susceptible to Mg loss, causing changes in carrier concentration through the formation of intrinsic defects. More severe degradation has further been observed for samples following contacting with a metal electrode, presenting an additional challenge for TEG technology advancement. We propose atomic layer deposition (ALD) to first enhance the material stability by suppression of Mg sublimation and second to differentiate between the different degradation mechanisms occurring at high operating temperatures. Our primary results from integral electrical conductivity and Seebeck coefficient measurements on coated samples without a Cu electrode at 723 K show enhanced material stability, while spatially resolved interface characterization of samples with Cu electrodes indicate comparable degradation for both coated and uncoated samples. This confirms Mg-Cu interdiffusion as the primary degradation mechanism for contacted samples with a higher relevance than Mg sublimation. Finally, wavelength-dispersive spectroscopy is used to reveal that the observed reduction in the charge carrier concentration during contacting is primarily due to Mg diffusing into the Cu electrode, not by the diffusion of Cu into the TE material as speculated previously, making this study the first to experimentally demonstrate the relevance of Mg loss into the electrode. By combining ALD coating to inhibit Mg loss with microstructural analysis, we present a methodology to distinguish TE material/electrode-related degradation mechanisms, enabling future advancements in Mg2(Si, Sn)-based TEGs.
- 29 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (19) , 28777-28788
Open AccessOn the Origin of Temperature Induced Performance Degradation of Cu-Contacted Mg2X-Based (X = Si, Sn) Thermoelectric Materials
Mg2X (X = Si, Sn)-based solid solutions are promising candidates for mid-to-high temperature waste heat recovery, but developing long-term stable thermoelectric generators (TEG) remains challenging. While Mg2X demonstrates excellent thermoelectric performance, it is susceptible to Mg loss, causing changes in carrier concentration through the formation of intrinsic defects. More severe degradation has further been observed for samples following contacting with a metal electrode, presenting an additional challenge for TEG technology advancement. We propose atomic layer deposition (ALD) to first enhance the material stability by suppression of Mg sublimation and second to differentiate between the different degradation mechanisms occurring at high operating temperatures. Our primary results from integral electrical conductivity and Seebeck coefficient measurements on coated samples without a Cu electrode at 723 K show enhanced material stability, while spatially resolved interface characterization of samples with Cu electrodes indicate comparable degradation for both coated and uncoated samples. This confirms Mg-Cu interdiffusion as the primary degradation mechanism for contacted samples with a higher relevance than Mg sublimation. Finally, wavelength-dispersive spectroscopy is used to reveal that the observed reduction in the charge carrier concentration during contacting is primarily due to Mg diffusing into the Cu electrode, not by the diffusion of Cu into the TE material as speculated previously, making this study the first to experimentally demonstrate the relevance of Mg loss into the electrode. By combining ALD coating to inhibit Mg loss with microstructural analysis, we present a methodology to distinguish TE material/electrode-related degradation mechanisms, enabling future advancements in Mg2(Si, Sn)-based TEGs.
- 26 February 2025
- Published by Wiley in Small Science
- Vol. 5 (3)
Instability Mechanism in Thermoelectric Mg2(Si,Sn) and the Role of Mg Diffusion at Room Temperature
- 26 February 2025
- Published by Wiley in Small Science
- Vol. 5 (3)
Instability Mechanism in Thermoelectric Mg2(Si,Sn) and the Role of Mg Diffusion at Room Temperature
- Open Access
- 16 February 2024
- Published by Elsevier in Materials & Design
- Vol. 239
Device level assessment of Ni and Ni45Cu55 as electrodes in Mg2(Si,Sn)-based thermoelectric generators
- 16 February 2024
- Published by Elsevier in Materials & Design
- Vol. 239
Open AccessDevice level assessment of Ni and Ni45Cu55 as electrodes in Mg2(Si,Sn)-based thermoelectric generators
- Open Access
- 14 February 2024
- Published by Wiley in Small Science
- Vol. 5 (3)
Instability Mechanism in Thermoelectric Mg2(Si,Sn) and the Role of Mg Diffusion at Room Temperature
Mg2(Si,Sn) shows great promise as thermoelectric material as it is made from non‐toxic, abundant, and cost‐effective elements offering high performance. This has been emphasized by several thermoelectric generator prototypes, demonstrating technological maturity. However, material stability is paramount for large‐scale applications whereas we reveal here that the thermal stability of n‐type Mg2(Si,Sn) may be limited even at room temperature (RT). Integral thermoelectric properties measurements, locally resolved Seebeck coefficient analysis, scanning electron microscopy/energy‐dispersive X‐ray spectroscopy, and atomic force microscopy are employed to assess changes of n‐type samples stored in ambient atmosphere for years, revealing the evolution of the carrier concentration and transport properties in the material as well as surface degradation. This is caused by the diffusion of loosely bound Mg from the bulk towards the surface and subsequent oxidation, leading to a change of Mg‐based intrinsic defect concentrations, thereby degrading the thermoelectric performance. This microscopic mechanism is backed up by first‐principles calculations, revealing that Mg diffusivity in Mg2(Si,Sn) is high at RT and that diffusion occurs mainly via Mg vacancies. The observed much faster degradation of Sn‐rich Mg2(Si,Sn) can be correlated with the higher density of Mg vacancies in Mg2Sn compared to Mg2Si, as predicted from defect formation energies.
- 14 February 2024
- Published by Wiley in Small Science
- Vol. 5 (3)
Open AccessInstability Mechanism in Thermoelectric Mg2(Si,Sn) and the Role of Mg Diffusion at Room Temperature
Mg2(Si,Sn) shows great promise as thermoelectric material as it is made from non‐toxic, abundant, and cost‐effective elements offering high performance. This has been emphasized by several thermoelectric generator prototypes, demonstrating technological maturity. However, material stability is paramount for large‐scale applications whereas we reveal here that the thermal stability of n‐type Mg2(Si,Sn) may be limited even at room temperature (RT). Integral thermoelectric properties measurements, locally resolved Seebeck coefficient analysis, scanning electron microscopy/energy‐dispersive X‐ray spectroscopy, and atomic force microscopy are employed to assess changes of n‐type samples stored in ambient atmosphere for years, revealing the evolution of the carrier concentration and transport properties in the material as well as surface degradation. This is caused by the diffusion of loosely bound Mg from the bulk towards the surface and subsequent oxidation, leading to a change of Mg‐based intrinsic defect concentrations, thereby degrading the thermoelectric performance. This microscopic mechanism is backed up by first‐principles calculations, revealing that Mg diffusivity in Mg2(Si,Sn) is high at RT and that diffusion occurs mainly via Mg vacancies. The observed much faster degradation of Sn‐rich Mg2(Si,Sn) can be correlated with the higher density of Mg vacancies in Mg2Sn compared to Mg2Si, as predicted from defect formation energies.
- Open Access
- 30 September 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (40) , 21716-21726
Establishing synthesis–composition–property relationships for enhanced and reproducible thermoelectric properties of MgAgSb
α-MgAgSb is a promising p-type thermoelectric (TE) with excellent performance from room temperature up to 300 °C with a figure of merit of zTmax = 1.3. This makes MgAgSb a potential Te-free bismuth telluride (Bi2Te3) substitute for cooling and waste heat conversion applications. However, the material is also known for its sensitivity on synthesis conditions as indicated by various reports on the same nominal composition which show greatly differing TE properties and performance. This indicates a fundamental lack of synthesis control and synthesis–composition–property relationship knowledge. In this work, we establish a modified synthesis route with improved control over the effective sample stoichiometry which allows for reproducible high-performance properties (zTmax = 1.34 ± 0.19 at 561 K) and for systematically targeting different thermodynamic states of MgAgSb. This phase boundary mapping reveals that the homogeneity range for MgAgSb is very small (<0.1 at%) and that the TE properties are not governed by different thermodynamic states. Instead, we rationalize that the TE performance of MgAgSb is mainly controlled by the amount and type of secondary phases, mainly affecting the carrier mobility. We conclude that Sb-excess related secondary phases are the least detrimental, leading the way to upscaled synthesis of high-performance material.
- 30 September 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (40) , 21716-21726
Open AccessEstablishing synthesis–composition–property relationships for enhanced and reproducible thermoelectric properties of MgAgSb
α-MgAgSb is a promising p-type thermoelectric (TE) with excellent performance from room temperature up to 300 °C with a figure of merit of zTmax = 1.3. This makes MgAgSb a potential Te-free bismuth telluride (Bi2Te3) substitute for cooling and waste heat conversion applications. However, the material is also known for its sensitivity on synthesis conditions as indicated by various reports on the same nominal composition which show greatly differing TE properties and performance. This indicates a fundamental lack of synthesis control and synthesis–composition–property relationship knowledge. In this work, we establish a modified synthesis route with improved control over the effective sample stoichiometry which allows for reproducible high-performance properties (zTmax = 1.34 ± 0.19 at 561 K) and for systematically targeting different thermodynamic states of MgAgSb. This phase boundary mapping reveals that the homogeneity range for MgAgSb is very small (<0.1 at%) and that the TE properties are not governed by different thermodynamic states. Instead, we rationalize that the TE performance of MgAgSb is mainly controlled by the amount and type of secondary phases, mainly affecting the carrier mobility. We conclude that Sb-excess related secondary phases are the least detrimental, leading the way to upscaled synthesis of high-performance material.
- Open Access
- 1 June 2022
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 3 (13) , 5418-5429
Effect of joining temperature on the interconnection zone and electrical resistance of Ag/n-Mg2Si and Ag/n-Mg2Sn contacts
1. Study of the Ag contacted n-type Mg2X (X = Si, Sn) TE materials. 2. Successful correlation of the observed phases at the n-Mg2X/Ag interconnection zones with the thermodynamically favorable phases. 3. Calculation of the electrical contact resistances.
- 1 June 2022
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 3 (13) , 5418-5429
Open AccessEffect of joining temperature on the interconnection zone and electrical resistance of Ag/n-Mg2Si and Ag/n-Mg2Sn contacts
1. Study of the Ag contacted n-type Mg2X (X = Si, Sn) TE materials. 2. Successful correlation of the observed phases at the n-Mg2X/Ag interconnection zones with the thermodynamically favorable phases. 3. Calculation of the electrical contact resistances.