Evaluation and prediction of cyclic response of Q690D steel
- 1 November 2017
- journal article
- Published by Emerald Publishing in Proceedings of the Institution of Civil Engineers - Structures and Buildings
- Vol. 170 (11) , 788-803
Abstract
High-strength structural steel of nominal yield strength greater than 690 MPa is difficult to produce in the hot-rolled condition without heat treatment. Quenching and tempering are thus commonly used to trade ductility for high strength. However, in seismic regions, good ductility of steel structural members is required to endure expected inelastic deformation under severe earthquake actions. This paper describes an experimental investigation on the mechanical properties and hysteretic behaviour of Q690D steel through 29 tensile coupon tests and 14 cyclic loading coupon tests subjected to four different cyclic patterns. The 16 mm and 40 mm quenched and tempered Q690D steel plates used in this study are equivalent to S690Q steel according to EN 10025-6. The test results of Q690D steel were compared with the ductility requirements of current seismic design codes. Under cyclic loading, Q690D steel showed cyclic softening. Based on analysis of the test results, a combined isotropic and kinematic hardening hysteretic model was developed to predict the cyclic behaviour of Q690D steel, with consideration of the Bauschinger effect and cyclic softening behaviour.Keywords
This publication has 32 references indexed in Scilit:
- Overall buckling behavior of 460MPa high strength steel columns: Experimental investigation and design methodJournal of Constructional Steel Research, 2012
- A review of some plasticity and viscoplasticity constitutive theoriesInternational Journal of Plasticity, 2008
- Cyclic response of plate steels under large inelastic strainsJournal of Constructional Steel Research, 2007
- High performance steel bridge girder compactnessJournal of Constructional Steel Research, 2002
- A new hysteresis model for steel membersInternational Journal for Numerical Methods in Engineering, 1999
- Model for Predicting Cyclic Behavior of Reinforcing SteelJournal of Structural Engineering, 1995
- Analysis of the bauschinger effectActa Metallurgica, 1986
- Time-independent constitutive theories for cyclic plasticityInternational Journal of Plasticity, 1986
- Plastic Internal Variables Formalism of Cyclic PlasticityJournal of Applied Mechanics, 1976
- A model of nonlinearly hardening materials for complex loadingActa Mechanica, 1975