Stress distribution of an anteriorly placed single implant in different clinical scenarios: a 3D finite element analysis
Authors:
Open Access
- 1 May 2026
- journal article
- Published by Springer Nature in BMC Oral Health
- Vol. 26
Abstract
Stress distribution around anterior dental implants may vary depending on implant placement timing and loading protocol. This study aimed to evaluate stress distributions around anteriorly placed single implants under different clinical scenarios using three-dimensional finite element analysis (FEA). Three clinical scenarios were simulated: (i) healed bone with delayed loading, (ii) healed bone with immediate loading, and (iii) immediate implant placement into a fresh extraction socket with immediate loading. Two abutment angulations (5° and 10°) were evaluated. Horizontal (25.5 N) and oblique (178 N at 30° to the implant long axis) forces were applied to the palatal surface of the restoration. Stress distributions in cortical and trabecular bone were assessed using maximum (P1) and minimum (P3) principal stresses, while von Mises stresses were calculated for the implant and abutment. In cortical bone, the highest tensile stress values occurred under oblique loading in the healed bone-immediate loading scenario (P1: 38.67-38.94 MPa), whereas minimal cortical stresses were observed in the immediate implant placement scenario (P1 ≤ 4.32 MPa). In trabecular bone, the highest stresses were recorded in the immediate implant placement with immediate loading, reaching P1 values of 11.20 MPa (5°) and 12.88 MPa (10°) under oblique loading, followed by healed bone with immediate loading (P1 up to 6.72 MPa). Oblique loading consistently generated higher stress values than horizontal loading. Increasing abutment angulation resulted in slightly higher stress magnitudes without altering stress distribution patterns. Stress distribution around anterior single implants is primarily influenced by the clinical placement and loading protocol. Immediate implant placement combined with immediate loading resulted in the highest stress concentrations, particularly in trabecular bone, whereas healed bone with delayed loading demonstrated the most favorable stress distribution. Abutment angulation had a secondary effect on stress magnitude.Keywords
All Related Versions
This publication has 41 references indexed in Scilit:
- Influence of Implant Design on the Biomechanical Environment of Immediately Placed Implants: Computed Tomography-Based Nonlinear Three-Dimensional Finite Element Analysis2011
- Three-dimensional finite element analysis of titanium and yttrium-stabilized zirconium dioxide abutments and implants.2011
- Modeling of the buccal and lingual bone walls of fresh extraction sites following implant installationClinical Oral Implants Research, 2006
- Finite Element Analysis of Different Bone Substitutes in the Bone Defects Around Dental ImplantsImplant Dentistry, 2006
- Three-dimensional finite element analysis of the effect of different bone quality on stress distribution in an implant-supported crownThe Journal of Prosthetic Dentistry, 2005
- Dimensional ridge alterations following tooth extraction. An experimental study in the dogJournal of Clinical Periodontology, 2005
- Finite element stress analysis of the effect of short implant usage in place of cantilever extensions in mandibular posterior edentulismJournal of Oral Rehabilitation, 2002
- Immediate implant placement and temporization in extraction and healing sites.2002
- Application of finite element analysis in implant dentistry: A review of the literatureThe Journal of Prosthetic Dentistry, 2001
- Biomaterials and biomechanics of oral and maxillofacial implants: current status and future developments.2000