Hydrostatically extruded glass‐fiber‐reinforced polyoxymethylene. I: The development of fiber and matrix orientation
Authors:
- 1 October 1996
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 17 (5) , 720-729
Abstract
This paper describes the determination of fiber and matrix orientation in oriented short‐glass‐fiber‐reinforced polyoxymethylene (POM) composites produced by hydrostatic extrusion. The starting material was random glass fibers (25 wt% and average length 150 μm) in an isotropic POM matrix, and the oriented composites were produced by extrusion through a reducing conical die at 15°C below the polymer melting point: after extrusion the average fiber length was reduced slightly to 133 μm. Fiber orientations were measured using an image analysis method developed at Leeds University, and the matrix orientation was determined using wide angle X‐ray diffraction. The development of fiber orientation with extrusion ratio was found to be close to that predicted by the pseudo‐affine deformation scheme although the fiber orientation was greater than that predicted by the model at low draw ratios and slightly less at the highest draw ratio. The development of the orientation of the crystalline portion of the matrix was found to be always significantly greater than that predicted by the pseudo‐affine scheme.Keywords
This publication has 16 references indexed in Scilit:
- Estimation of the directional distribution of spatial fibre processes using stereology and confocal scanning laser microscopyJournal of Microscopy, 1994
- Measurements of fibre direction in reinforced polymer compositesJournal of Microscopy, 1993
- Measurement of small angle fiber misalignments in continuous fiber compositesComposites Science and Technology, 1987
- The Cosmos image analyserPattern Recognition Letters, 1986
- Modulus development in oriented short‐glass‐fiber‐reinforced polymer compositesPolymer Composites, 1982
- The hydrostatic extrusion and die‐drawing of glass‐fiber‐reinforced polyoxymethylenePolymer Engineering & Science, 1982
- Manufacture of high stiffness solid rods by the hydrostatic extrusion of linear polyethylene. Part I: Influence of processing conditionsPolymer Engineering & Science, 1980
- Hydrostatic extrusion of polyoxymethyleneJournal of Polymer Science: Polymer Physics Edition, 1978
- The measurement of molecular orientation in polymers by spectroscopic techniquesJournal of Polymer Science: Polymer Symposia, 1977
- Optical and Mechanical Anisotropy in Crystalline PolymersProceedings of the Physical Society (1958-1967), 1962