The Heat Transfer Enhancement Mechanism of Paraffin by Graphene Nanoparticles for Varying Heat Flux Density
- 22 July 2026
- journal article
- research article
- Published by Wiley in Energy Technology
- Vol. 14 (7) , e70592
Abstract
Phase‐change thermal storage technology can effectively address the issues of uneven spatial and temporal distribution of solar energy and low energy density. However, the low thermal conductivity of phase‐change materials (PCMs) limits their application range. Adding high thermal conductivity materials is an important approach to enhance the thermal conductivity of PCMs. In this paper, different mass fractions (0.5%, 1.0%, 1.5%, and 2.0%) of graphene/paraffin composite PCMs (nanoparticles [NPs]) were prepared using the melt blending method. The effects of heat flux density (5.0, 10.0, and 15.0 kW/m 2 ) on the melting heat transfer enhancement mechanism and thermal storage characteristics of the composite PCMs were deeply investigated. The research results show that increasing heat flux density can enhance natural convection during the melting process of the composite PCMs and significantly shorten the melting time. When the heat flux density increases from 5.0 to 15.0 kW/m 2 , the melting time is reduced by 158.9%. However, the addition of graphene inhibits natural convection, and the greater the mass fraction of graphene, the more pronounced the inhibition. The enhancement of natural convection by heat flux density is not sufficient to offset the inhibition of natural convection heat transfer by graphene. When the heat flux density increases from 5.0 to 15.0 kW/m 2 , compared to 0.5% NP, the Rayleigh number and Nusselt number increase by 44.9% and 23.0%, respectively, for 2.0% NP. In addition, heat flux density can significantly enhance thermal storage performance. When the heat flux density increases from 5.0 to 15.0 kW/m 2 , the thermal storage capacity increases by 39.1%, 43.2%, 43.3%, and 44.2% for 0.5% NP, 1.0% NP, 1.5% NP, and 2.0% NP, respectively. The 1.5% NP composite PCM exhibits the best thermal storage characteristics.Keywords
Funding Information
- National Natural Science Foundation of China (51606126)
- National Natural Science Foundation of China (51876130)
- Natural Science Foundation of Shanghai Municipality (20ZR1438600)
This publication has 39 references indexed in Scilit:
- Novel optimal high pressure determination method for CO2 air source heat pump water heater: Experimental study and methodology developmentApplied Thermal Engineering, 2024
- Recent advances in nano-enhanced phase change materialsJournal of Materials Science, 2023
- Experimental study on latent thermal energy storage system with gradient porosity copper foam for mid-temperature solar energy applicationApplied Energy, 2020
- Effect of porous medium and nanoparticles presences in a counter-current triple-tube composite porous/nano-PCM systemApplied Thermal Engineering, 2020
- Effect of nanomaterial addition on the thermophysical properties of Iraqi paraffin waxCase Studies in Thermal Engineering, 2019
- Improved performance of a newly prepared nano-enhanced phase change material for solar energy storageJournal of Mechanical Science and Technology, 2017
- Thermal properties of beeswax/graphene phase change material as energy storage for building applicationsApplied Thermal Engineering, 2017
- Thermal conductivity enhancement of lauric acid phase change nanocomposite with graphene nanoplateletsApplied Thermal Engineering, 2015
- An investigation of melting/freezing characteristics of nanoparticle-enhanced phase change materialsJournal of Thermal Analysis and Calorimetry, 2011
- The correlation between the number of fins and the discharge time for a finned heat pipe latent heat storage systemRenewable Energy, 1996