Investigation of the Warpage of a High-Density Polyethylene Pallet by Plastic Injection Compression Molding: Part I—Numerical Approach
Open Access
Abstract
Many challenges are associated with the injection compression molding process for producing a half-pallet (1320 mm × 1110 mm × 75 mm, length × width × height), which is butt-welded to another one for enhancing its strength. This pooled high-density polyethylene (HDPE) pallet is able to endure the impacts of a heavy load and a low ambient temperature. Reducing the warpage of a half-pallet is, therefore, essential for reducing the residual internal stress within the welded portions. An advanced Moldex3D package helps to detail the temperature distribution and warpage of a half-pallet. The pre-setting molding parameters from a mass-production factory produce half-pallets with worse flatness. In this investigation on using appropriate cooling water temperatures within the core and cavity plates of the mold, the numerical results show that the warpage of the top surface of the half-pallet was 11.549 mm, low warpage with respect to this large-scale pallet. Furthermore, the compression speed of 50–60 mm/s may have produced a low flatness of the half-pallet in this study.Keywords
This publication has 31 references indexed in Scilit:
- Numerical Simulation and Experimental Investigation of the Viscoelastic Heating Mechanism in Ultrasonic Plasticizing of Amorphous Polymers for Micro Injection MoldingPolymers, 2016
- Static and Dynamic Properties of Semi-Crystalline PolyethylenePolymers, 2016
- Numerical simulation for flow‐induced stress in injection/compression moldingPolymer Engineering & Science, 2015
- Laser transmission welding of composites-Part A: Thermo-physical and optical characterization of materialsInfrared Physics & Technology, 2015
- Warpage control of thin-walled injection molding using local mold temperaturesInternational Communications in Heat and Mass Transfer, 2015
- Three‐dimensional numerical analysis of injection‐compression molding processPolymer Engineering & Science, 2011
- Effect of Mold Temperature on Mechanical Properties of an Injection-Molded Part with MicrofeaturesJournal of Polymer Engineering, 2009
- Warpage prediction of optical mediaJournal of Polymer Science Part B: Polymer Physics, 2003
- Numerical simulation of mold filling in injection molding using a three‐dimensional finite volume approachInternational Journal for Numerical Methods in Fluids, 2001
- Experiments on the hot-tool welding of three dissimilar thermoplasticsPolymer, 1998