Numerical simulation for flow‐induced stress in injection/compression molding
Authors:
- 12 December 2015
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 56 (3) , 287-298
Abstract
Flow‐induced stress in compression stage is complex because compression flow combines both shear flow and extensional flow characters and involves the boundary change in melt front and compressing directions. To describe this kind of flow effectively, the theoretical model was established in terms of three‐dimensional compressible and viscoelastic fluid, and the material derivative which includes mesh moving velocity was introduced to modify the convective terms in governing and constitutive equations based on Arbitrary Lagrangian Eulerian description. The corresponding variational equations were derived via Gauss formula and the finite element method was used to discretize the flow variables with mixed elements. In order to decouple the interdependence of velocity, stress, and temperature, a new approach involves twofold iterations was proposed to solve nonlinear flow problem. A new mesh updating scheme was presented to keep consistent with compressed regions. Numerical results indicate the compression can reduce the flow‐induced stress significantly compared to conventional injection molding, increase compressing velocity enlarges flow‐induced stress, and high temperature decreases flow‐induced stress. The proposed method was verified by photoelastic pictures and measured pressures and temperatures during molding. POLYM. ENG. SCI., 56:287–298, 2016. © 2015 Society of Plastics EngineersKeywords
Funding Information
- National Science Foundation of China (11272291, 11372285)
- Major State Basic Research Development Program of China (2012CB025900)
- Basic Research Foundation Henan Science and Technology Committee (142300410029)
This publication has 18 references indexed in Scilit:
- Numerical simulations of the planar contraction flow for a polyethylene melt using the XPP modelJournal of Non-Newtonian Fluid Mechanics, 2004
- Differential viscoelastic constitutive equations for polymer melts in steady shear and elongational flowsJournal of Non-Newtonian Fluid Mechanics, 2003
- Viscoelastic analysis of complex polymer melt flows using the eXtended Pom–Pom modelJournal of Non-Newtonian Fluid Mechanics, 2002
- Simulation of injection‐compression molding process, Part 3: Effect of process conditions on part birefringenceAdvances in Polymer Technology, 2002
- An Arbitrary Lagrangian–Eulerian Computing Method for All Flow SpeedsJournal of Computational Physics, 1997
- A new mixed finite element method for computing viscoelastic flowsJournal of Non-Newtonian Fluid Mechanics, 1995
- Styrene maleic anhydride and styrene glycidyl methacrylate copolymers as in situ reactive compatibilizers of polystyrene/nylon 6,6 blendsPolymer Engineering & Science, 1991
- A new approach for the FEM simulation of viscoelastic flowsJournal of Non-Newtonian Fluid Mechanics, 1989
- A new mixed finite element for calculating viscoelastic flowJournal of Non-Newtonian Fluid Mechanics, 1987
- Compressive flow between parallel disks: II. oscillatory behavior of viscoelastic materials under a constant loadJournal of Non-Newtonian Fluid Mechanics, 1984