Studies of the Effect of High Voltage on the Impedance and Cycling Performance of Li[Ni0.4Mn0.4Co0.2]O2/Graphite Lithium-Ion Pouch Cells
Authors:
Open Access
- 27 February 2015
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 162 (6) , A1046-A1054
Abstract
Li[Ni0.4Mn0.4Co0.2]O2 (NMC442)/graphite pouch cells containing various electrolyte additives, either singly or in combination, were studied using cycling experiments up to 4.4 and 4.5 V coupled with simultaneous electrochemical impedance spectroscopy (EIS) measurements. The impedance of most cells increased dramatically at 4.4 and 4.5 V, but was nearly reversible over one cycle. However, during continued cycling, the impedance of all cells slowly increased at all potentials. Electrolyte additives were found to dramatically affect this behavior. The impacts of adding prop-1-ene-1,3-sultone (PES), vinylene carbonate (VC), triallyl phosphate (TAP), methylene methane disulfonate (MMDS), ethylene sulfate (DTD) and/or tris(-trimethyl-silyl)-phosphite (TTSPi) to 1M LiPF6 ethylene carbonate:ethyl methyl carbonate (EC:EMC) electrolyte were studied. PES-containing cells had dramatically lower impedance and better capacity retention than VC and TAP-containing cells during both 4.4 and 4.5 V experiments. When MMDS, DTD and/or TTSPi were added in combination with PES, the performance was improved further. Finally, continuous charge-discharge cycling was compared to cycling with a 24-hour hold applied at the top of charge at 4.4 V. The high voltage hold led to severe impedance growth which could be partially overcome through the use of optimal additive combinations.Keywords
This publication has 22 references indexed in Scilit:
- Studies of the Effect of Varying Prop-1-ene-1,3-sultone Content in Lithium Ion Pouch CellsJournal of the Electrochemical Society, 2014
- Comparative Study on Prop-1-ene-1,3-sultone and Vinylene Carbonate as Electrolyte Additives for Li(Ni1/3Mn13Co1/3)O2/Graphite Pouch CellsJournal of the Electrochemical Society, 2014
- Study of Methylene Methanedisulfonate as an Additive for Li-Ion CellsJournal of the Electrochemical Society, 2013
- A novel electrolyte with the ability to form a solid electrolyte interface on the anode and cathode of a LiMn2O4/graphite batteryJournal of Materials Chemistry A, 2013
- Fluoropropane sultone as an SEI-forming additive that outperforms vinylene carbonateJournal of Materials Chemistry A, 2013
- Properties of solid electrolyte interphase formed by prop-1-ene-1,3-sultone on graphite anode of Li-ion batteriesElectrochimica Acta, 2013
- Predicting and Extending the Lifetime of Li-Ion BatteriesJournal of the Electrochemical Society, 2013
- Tuning glycolide as an SEI-forming additive for thermally robust Li-ion batteriesJournal of Materials Chemistry, 2012
- Impedance Reducing Additives and Their Effect on Cell PerformanceJournal of the Electrochemical Society, 2012
- Main aging mechanisms in Li ion batteriesJournal of Power Sources, 2005