Spin coated multilayered CuO/ZnO films with high output power under irradiation
- 11 December 2018
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (3) , 036415
Abstract
Thin films of pure CuO, pure ZnO and CuO/ZnO multilayers were synthesized using spin coating technique. CuO and ZnO layers were spin coated for 30 s at speeds of 2000 and 1500 rpm, respectively. All the samples were subsequently annealed at 500 0C for one hour in air. Structural properties of films investigated using XRD patterns indicated the crystallization of single phase of CuO and ZnO. Optical band gaps of samples determined by UV-visible spectrums were in the range of the band gaps of CuO and ZnO. The main objective of the preparation of multilayered CuO/ZnO was enhancing the output power by combining wide band gap and narrow band gap materials. CuO with higher photocurrent and ZnO with higher photovoltage were employed to achieve this task. Photocurrent, photovoltage and impedance were measured in order to investigate electrical properties of samples. A liquid junction photocell with electrolyte KI was employed to measure photovoltaic properties. Multilayer with ZnO as the top layer provides a higher output power of 3.6088 µW/cm2 compared to the output power of multilayer with CuO as the top layer (1.101 µW/cm2). This is the highest output power reported for a multilayer of CuO/ZnO without any dye coating in KI electrolyte. The highest output power of our multilayered samples is more than twice the previously reported highest output powers of pure CuO and pure ZnO thin film samples without dye coating. Structural properties of samples were confirmed by FTIR. Crystallite size was in the range from 23.41 to 28.51 nm. Impedance curves of all the samples were measured under dark and light conditions. Two semicircles could be observed at Nyquist plots of both multilayer samples.Keywords
This publication has 34 references indexed in Scilit:
- Fabrication and characterization of CuO/ZnO solar cellsJournal of Physics: Conference Series, 2012
- Synthesis and characterization of CuO nanowires by a simple wet chemical methodDiscover Nano, 2012
- Influence of deposition temperature on the crystallinity of Al-doped ZnO thin films at glass substrates prepared by RF magnetron sputtering methodSuperlattices and Microstructures, 2011
- Improved Efficiency of Dye-Sensitized Solar Cell Using Graphene-Coated Al2O3-TiO2Nanocomposite PhotoanodeMolecular Crystals and Liquid Crystals, 2011
- Photoluminescence, FTIR and X-ray diffraction studies on undoped and Al-doped ZnO thin films grown on polycrystalline α-alumina substrates by ultrasonic spray pyrolysisJournal of Luminescence, 2010
- Vacancy-Mediated Magnetism in Pure Copper Oxide NanoparticlesDiscover Nano, 2010
- Preparation of highly textured surface ZnO thin filmsMaterials Science and Engineering: B, 2006
- The effect of substrate temperature on the structural and some physical properties of ultrasonically sprayed CdS filmsMaterials Chemistry and Physics, 2005
- Comparison of the structural and optical properties of zinc oxide thin films deposited by d.c. and r.f. sputtering and spray pyrolysisSurface and Coatings Technology, 2005
- III. Dislocation densities in some annealed and cold-worked metals from measurements on the X-ray debye-scherrer spectrumPhilosophical Magazine, 1956