Enthalpy–Temperature Characterisation of Organic Phase Change Materials Using a Common T-History Framework
Open Access
- 16 October 2026
- journal article
- research article
- Published by MDPI AG in Electronics
- Vol. 15 (20) , 4785
Abstract
Phase change materials can exhibit markedly different thermal responses during cooling, ranging from narrow single-stage transitions to broad or multistage behaviour, which requires the analysis procedure to account for differences in response structure. This study applies a common water-referenced T-history framework to the enthalpy–temperature characterisation of six organic phase change materials: RT35HC, RT45HC, lauric acid, beeswax, palmitic acid and soy wax. Five experiments were reported for each material. The enthalpy was obtained from small, matched temperature intervals in the same way for every material, while the low-temperature calorimetric boundary was derived from the measured cooling response rather than imposed as a fixed temperature criterion. Thermal responses were described by cumulative temperatures at the 5%, 50% and 95% levels of the detected thermal effect. The T-history enthalpy changes were 207.35 ± 32.31, 197.59 ± 23.31, 224.11 ± 32.48, 200.38 ± 17.47, 191.50 ± 15.16 and 109.37 ± 13.33 J/g for RT35HC, RT45HC, lauric acid, beeswax, palmitic acid and soy wax, respectively. Comparison with differential scanning calorimetry measurements of the tested samples, independent calorimetric studies, manufacturer data and published thermal data supported the identified temperature regions and response structures. The enthalpy values were interpreted separately, taking into account differences in calorimetric definitions and temperature intervals. Changing the detector settings changed the mean primary midpoint temperature by less than 0.03 K for every material, while changing the matched temperature interval from the nominal 0.250 K to 0.125 K or 0.500 K changed the mean enthalpy by at most 2.29%. The results show that a common T-history framework can characterise substantially different cooling behaviours of the phase change materials when calorimetric boundaries are derived from the measured thermal response. The resulting characteristics also provide material-level information relevant to the selection of PCMs for electronic thermal management applications.Keywords
Funding Information
- Gdańsk University of Technology grant, awarded within the Radium Learning Through Research Programs of the "Excellence Initiative – Research University" programme (DEC-10/1/2025/IDUB/III.1a/Ra)
- Narodowym Centrum Nauki (OPUS 24 2022/47/B/ST8/01490)
This publication has 39 references indexed in Scilit:
- Preparation of enhanced phase change materials using nitride additives and thermal characterization analysisJournal of Mechanical Science and Technology, 2026
- Development of a graphite biodegradable composite based on NADES and soy wax association applied as a binder for carbon paste electrodesJournal of Solid State Electrochemistry, 2026
- Temperature-history method for characterizing thermophysical properties of phase change materials: a critical reviewJournal of Thermal Analysis and Calorimetry, 2025
- Advanced hybrid thermal management system for LTO battery module under fast chargingCase Studies in Thermal Engineering, 2022
- Analytical modelling of PCM supercooling including recalescence for complete and partial heating/cooling cyclesApplied Thermal Engineering, 2021
- Performance of beeswax phase change material (PCM) and heat pipe as passive battery cooling system for electric vehiclesCase Studies in Thermal Engineering, 2020
- Thermal properties optimization of microencapsulated a renewable and non-toxic phase change material with a polystyrene shell for thermal energy storage systemsApplied Thermal Engineering, 2018
- Thermal Energy Storage Using Phase Change Materials2015
- Heat pipe with PCM for electronic coolingApplied Energy, 2011
- Determination of the enthalpy of PCM as a function of temperature using a heat-flux DSC-A study of different measurement procedures and their accuracyInternational Journal of Energy Research, 2008