The Influence of A Cross-Channel Extrusion Process on The Microstructure and Properties of Copper
Open Access
Abstract
A new cross-channel extrusion (CCE) method with the application of a back pressure (BP) is proposed and experimentally tested. The introduction of pressure blocks the free flow of material by using an additional set of pistons, which prevents the loss of consistency. The paper presents results of experimental trials of CCE process. Between one and eight passes of CCE with and without a BP were applied to pure copper billets to refine their initial coarse-grained microstructure at room temperature. It was found that processing by CCE results in the formation of a lamellar structure along the extruded axis and the fine-grained structure in the remaining volume. The material exhibited dynamic recrystallization, which results in the formation of 0.5- to 2-μm grains after one pass and 2- to 8-μm grains after four CCE passes. The fine-grained material had YS of 390-415 MPa. An increase in the microhardness from 70 to 130 HV02 after one pass and then a decrease after four passes were observed. This might indicate that secondary recrystallization and selective grain growth occur, because an exothermic peak (158.5 °C, 53 ± 2.1 J/mol) was observed during DSC (differential scanning calorimetry) testing. The resistivity of the once deformed copper significantly decreases, while its further processing causes the resistivity to increase.Keywords
Funding Information
- Ministry of National Defense Republic of Poland (13-995)
This publication has 68 references indexed in Scilit:
- The influence of large particles of iron powder on the microstructure and properties of FeAl intermetallic phaseIntermetallics, 2019
- Influence of heat treatment on the formation of ultrafine-grained structure of Al–Li alloys processed by SPDArchives of Civil and Mechanical Engineering, 2018
- Microstructure and mechanical properties of a Fe-28%Al-5%Cr-1%Nb-2%B alloy fabricated by Laser Engineered Net ShapingMaterials Letters, 2017
- Twenty-five years of ultrafine-grained materials: Achieving exceptional properties through grain refinementActa Materialia, 2013
- Severe plastic deformation (SPD) processes for metalsCIRP Annals, 2008
- Grain refinement of commercially pure zirconium by ECAP and subsequent intermediate heat treatmentMaterials Science and Engineering: A, 2007
- Fatigue limit and crack growth in ultra-fine grain metals produced by severe plastic deformationJournal of Materials Science, 2006
- Producing bulk ultrafine-grained materials by severe plastic deformationJOM, 2006
- The mechanism of nanocrystalline structure formation in Ni3Al during severe plastic deformationActa Materialia, 2001
- Bulk nanostructured materials from severe plastic deformationProgress in Materials Science, 2000