Integration of Process Simulation in Machining Parameter Optimization
Authors:
- 1 February 1999
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 121 (1) , 134-143
Abstract
In recent years, simulation tools have proven valuable for the prediction of machining state variables over a wide range of operating parameters. Such simulation packages, however, are seldom an integral part of machining parameter optimization modules. This paper proposes a methodology for incorporating simulation feedback to fine-tune analytic models during the optimization process. Through a limited number of calls to the computationally expensive simulation tools, process parameters may be generated that satisfy the design constraints within the accuracy of the simulation predictions, while providing an efficient balance among parameters arising from the functional form of the optimization model. The following iterative algorithm is presented: (i) a non-linear programming (NLP) optimization technique is used to select process parameters based on closed-form analytical constraint equations relating to critical design requirements, (ii) the simulation is executed using these process parameters, providing predictions of the critical state variables. (iii) Constraint equation parameters are dynamically adapted using the feedback provided by the simulation predictions. This sequence is repeated until local convergence between the simulation and constraint equation predictions has been achieved. A case study in machining parameter optimization for peripheral finish milling operations is developed in which constraints on the allowable form error,Δ and the peripheral surface roughness, Ra, drive the process parameter selection for a cutting operation intended to maximize the material removal rate. Results from twenty machining scenarios are presented, including five workpiece/tool material combinations at four levels of precision. Achieving agreement (within a 5% deviation tolerance) between the simulation and constraint equation predictions required an average of 5 simulation execution cycles (maximum of 8), demonstrating promise that simulation tools can be efficiently incorporated into parameter optimization processes.Keywords
This publication has 16 references indexed in Scilit:
- A generalized multi-pass machining model for machining parameter selection in turningInternational Journal of Production Research, 1995
- An Enhanced End Milling Surface Texture Model Including the Effects of Radial Rake and Primary Relief AnglesJournal of Engineering for Industry, 1994
- The Optimization of Machining Operations Based on a Combined Criterion, Part 1: The Use of Combined Objectives in Single-Pass OperationsJournal of Engineering for Industry, 1992
- Simultaneous determination of optimal machining conditions and tool replacement policies in constrained machining economics problems by geometric programmingInternational Journal of Production Research, 1991
- A Discrete Data Base Multiple Objective Optimization of Milling Operation Through Geometric ProgrammingJournal of Engineering for Industry, 1990
- A Comparison of Statistical and AI Approaches to the Selection of Process Parameters in Intelligent MachiningJournal of Engineering for Industry, 1990
- Analysis of optimal machining speeds for automatic manufacturingInternational Journal of Production Research, 1989
- A survey of expert systems in manufacturing and process planningComputers in Industry, 1989
- The effect of runout on cutting geometry and forces in end millingInternational Journal of Machine Tool Design and Research, 1983
- The prediction of cutting forces in end milling with application to cornering cutsInternational Journal of Machine Tool Design and Research, 1982