A Reflection Coefficient Estimation Method for Power Cable Defects Based on Three-Point Interpolated FFT
- 25 December 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 73 (00189456) , 1-8
Abstract
The reflection coefficient of reflected wave is one of the most important parameters to characterize the damage degree of power cable defect. However, due to the attenuation and the crossing coupling among the reflection coefficients of each defect, the reflection coefficient of the reflected wave can be hardly estimated, resulting in inaccurate power cable fault diagnosis. Thus, a method based on three-point interpolation fast Fourier transform (FFT) to estimate the reflected amplitude of cable defects is proposed. First, three adjacent points on each spectral peak in the frequency domain are selected to accurately analyze the exponential signal in the frequency domain, and gain the parameters including the amplitude and phase of the reflected wave at the defect. Then, the state of the defect is evaluated by the reflection coefficient at the defect. Finally, the simulation result shows both the amplitude and phase relative errors of the proposed method are less than 10%, meanwhile the experiment results prove the proposed method can accurately judge the state of the cable defect.Keywords
Funding Information
- National Natural Science Foundation of China (52107185)
- Sichuan University Postdoctoral Research and Development Fund (2023SCU12005)
This publication has 26 references indexed in Scilit:
- Algorithms for Locating and Characterizing Cable Faults via Stepped-Frequency Waveform ReflectometryIEEE Transactions on Instrumentation and Measurement, 2020
- Modeling of High-Frequency Current Transformer Based Partial Discharge Detection in High-Voltage CablesIEEE Transactions on Power Delivery, 2019
- A Fourier-EWT Approach for Identifying the Low Frequency Modes Present in the Power System2018
- Condition Assessment of I&C Cables in Nuclear Power Plants via Stepped-Frequency Waveform ReflectometryIEEE Transactions on Instrumentation and Measurement, 2018
- Locating Faults With High Resolution Using Single-Frequency TR-MUSIC ProcessingIEEE Transactions on Instrumentation and Measurement, 2016
- Effects of the structure and insulation material of a cable on the ability of a location method by FDRIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Local degradation diagnosis for cable insulation based on broadband impedance spectroscopyIEEE Transactions on Dielectrics and Electrical Insulation, 2015
- Power System Osciliation Modes Identification Based on Eigen system Realization Algorithm via Empirical Mode DecompositionEnergy Procedia, 2012
- Detection and Location of Defects in Wiring Networks Using Time-Domain Reflectometry and Neural NetworksIEEE Transactions on Magnetics, 2011
- Analysis of the Exponential Signal by the Interpolated DFT AlgorithmIEEE Transactions on Instrumentation and Measurement, 2010