Stress-Strain Response of Cylindrical Rubber Fender under Monotonic and Cyclic Compression
Open Access
Abstract
The study was devoted to the observation and modeling the mechanical behaviors of a hybrid SBR/NR (Styrene-Butadiene/Natural Rubber) hybrid vulcanized rubber fender under monotonic/cyclic compression. In experimental observations of the monotonic compression tests, it was found that lateral deformation occurred on the tested fender and was more significant with increasing the extent of the compressive strain. The relationship between the transmission stress and the compressive strain was nonlinear and the absorbed strain-energy-density was increased monotonically with the increment of the compressive strain. Among all cyclic compression tests with strain controlled, the reductions in both the stress range and the absorbed strain-energy-density up to the ten-thousandth cycle were found and then both of the cyclic properties remain approximately constant in the following compression cycles. Two new properties, the softening factor and the energy reduction factor, were introduced to quantify the effect of the strain range on the extent of the reduction in stress range and that on the absorbed strain-energy-density, respectively. It was found that both of the calculated values of the new properties increase with the increment of strain range. In mathematical modeling of the relationship between the transmission stress and the compressive strain, a new approach based on energy-polynomial-function was presented and was successfully used to simulate the monotonic curve and the stable hysteresis loop curves of the tested rubber fender in compression. Essentially, the energy-polynomial-function was obtained by performing a polynomial regression on a large amount of ( data. Moreover, the least-square approach was applied to determine the corresponding regression coefficients in . Clearly, the stress-polynomial-function in modeling the curve could be obtained from the differentiation of the energy-polynomial-function with respect to the compressive strain. In addition, to provide an adequate estimation of the mechanical properties of the cylindrical rubber fender under compression, the named cyclic stress-strain curve and cyclic energy-strain curve were developed and also modeled in this study.
Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (105-2221-E-415-007)
This publication has 17 references indexed in Scilit:
- Multiaxial fatigue life predictors for rubbers: Application of recent developments to a carbon-filled SBRInternational Journal of Fatigue, 2014
- Experimental characterization and modelling of the cyclic softening of carbon-black filled rubbersMaterials Science and Engineering: A, 2011
- Mechanical performance of styrene-butadiene-rubber filled with carbon nanoparticles prepared by mechanical mixingMaterials Science and Engineering: A, 2011
- Response of a carbon-black filled SBR under large strain cyclic uniaxial tensionInternational Journal of Fatigue, 2010
- Effects of cyclic compression and thermal aging on dynamic properties of neoprene rubber bearingsJournal of Applied Polymer Science, 2007
- Effects of thermal aging on fatigue of carbon black–reinforced EPDM rubberJournal of Applied Polymer Science, 2006
- Fatigue life estimation of an engine rubber mountInternational Journal of Fatigue, 2004
- Fatigue initiation and propagation in natural and synthetic rubbersInternational Journal of Fatigue, 2002
- Aging of ethylene-propylene diene rubber (EPDM) vulcanized by γ-radiationPolymer Testing, 2000
- Effect of aging and carbon black on the mechanical properties of EPDM rubberPolymer Testing, 1998