Enhancing Hardness and Wear Performance of Laser Additive Manufactured Ti6Al4V Alloy Through Achieving Ultrafine Microstructure
Open Access
Abstract
Refining microstructure is an important issue for laser additive manufacturing (LAM) of titanium alloy. In the present work, the microstructures of LAM-fabricated Ti6Al4V alloy were refined using a low energy density with the combination of a small spot diameter, a low laser power, and a high scanning speed. The microstructure, hardness, wear performance, and molten pool thermal behavior of LAM-fabricated Ti6Al4V coatings were studied. The results show that the grain sizes of both prior β and α phases are strongly dependent on the cooling rate of the molten pool. The fine prior β grains and submicron-scale acicular α phases were obtained under a low energy density of 75 J mm−2 due to the high cooling rate of the molten pool. In addition, the as-fabricated Ti6Al4V sample with submicron-scale acicular α phase showed a very high hardness of 7.43 GPa, a high elastic modulus of 133.6 GPa, and a low coefficient of friction of 0.48. This work provides a good method for improving the microstructure and mechanical performance of LAM-fabricated Ti6Al4V alloy.Keywords
Funding Information
- China Postdoctoral Science Foundation (No.2018M642973)
- National Natural Science Foundation of China (No. 51875190)
- Science and Technology Planning Project of Hunan Province (No. 2016JC2006)
- State Key Laboratory of Advanced Design and Manufacturing for Vehicle Body at Hunan University (No. 31875004)
This publication has 41 references indexed in Scilit:
- Microstructure and deformation behavior of Ti-6Al-4V alloy by high-power laser solid formingActa Materialia, 2017
- Graded microstructure and mechanical properties of additive manufactured Ti–6Al–4V via electron beam meltingActa Materialia, 2015
- Anisotropic tensile behavior of Ti–6Al–4V components fabricated with directed energy deposition additive manufacturingActa Materialia, 2015
- Additive Manufacturing of Ti-6Al-4V Using a Pulsed Laser BeamMetallurgical and Materials Transactions A, 2015
- Evaluation of defect density, microstructure, residual stress, elastic modulus, hardness and strength of laser-deposited AISI 4340 steelActa Materialia, 2015
- Densification behavior, microstructure evolution, and wear performance of selective laser melting processed commercially pure titaniumActa Materialia, 2012
- Grain size–wear rate relationship for titanium in liquid nitrogen environmentActa Materialia, 2010
- Fabrication of Ti-6Al-4V Scaffolds by Direct Metal DepositionMetallurgical and Materials Transactions A, 2008
- Microstructural evolution in laser-deposited multilayer Ti-6Al-4V builds: Part I. Microstructural characterizationMetallurgical and Materials Transactions A, 2004
- The volume expansion accompanying the martensite transformation in iron-carbon alloysMetallurgical Transactions A, 1975