Calibration of High-Frequency Mechanical Impact Simulation Based on Drop Tests
Open Access
- 4 May 2020
- journal article
- research article
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 29 (8) , 4879-4887
Abstract
A series of drop tests was implemented in the present study in order to allow the reproduction of a single impact identical to the high frequency mechanical impact (HFMI) under monitored conditions in the laboratory. Therewith, characterization of the investigated material’s mechanical behavior by explicitly considering possible irregularities concerning the present deformation modes would be enabled. Main goal was the determination of the investigated material’s dynamic yield stress for various strain rates inside the spectrum of interest, so that the Cowper–Symonds viscous material model would be calibrated for the subsequent HFMI simulation. The values of the dynamic yield stress extracted by the present drop tests show good agreement with other experimental methods regarding the investigated material S355. The introduction of the calibrated material behavior on the present drop tests in the finite element (FE) analysis of HFMI led to reduced preciseness though, in comparison with the FE analysis, which considered high strain rate tensile tests found in literature. A series of conclusions was drawn from both the experimental and numerical investigations, confirming most of the initial expectations. Further work is proposed, in order to clarify an incompatibility met during the numerical investigations.Keywords
This publication has 26 references indexed in Scilit:
- High strain rate response of S355 at high temperaturesMaterials & Design, 2016
- Quality assurance for high-frequency mechanical impact (HFMI) treatment of welds using handheld 3D laser scanning technologyWelding in the World, 2014
- Fatigue strength improvement of steel structures by high-frequency mechanical impact: proposed procedures and quality assurance guidelinesWelding in the World, 2013
- Overview of Fatigue Data for High Frequency Mechanical Impact Treated Welded JointsWelding in the World, 2012
- A 3D FE model with plastic shot for evaluation of equi-biaxial peening residual stress due to multi-impactsSurface and Coatings Technology, 2012
- A simple but effective FE model with plastic shot for evaluation of peening residual stress and its experimental validationMaterials Science and Engineering: A, 2011
- Numerische Schweißsimulation gekoppelt mit einem anschließenden Hämmerprozess und integrierten lokalen ErmüdungsberechnungenStahlbau, 2009
- Lebens- und Restlebensdauerverlängerung geschweißter Windenergieanlagentürme und anderer Stahlkonstruktionen durch SchweißnahtnachbehandlungStahlbau, 2005
- Contact MechanicsJournal of Tribology, 1986
- Fundamental Problems in Viscoplasticity1966