Montmorillonite-Regulated C3N4/Co3O4 Interface Enables Sustained Radical-Driven Photocatalytic Peroxymonosulfate Oxidation of Bisphenol A
- 22 October 2026
- journal article
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (43) , 32036-32053
Abstract
Interfacial regulation provides a route to couple charge separation, Co-site chemistry, and peroxymonosulfate (PMS) activation in photocatalytic oxidation. Here, a montmorillonite-regulated C3N4/Co3O4 photocatalyst (MCNCo) was constructed for light-assisted BPA degradation. MCNCo achieved 85.2% BPA removal within 60 min, compared with 70.2% for CNCo, despite its lower specific surface area and substantially lower bulk Co content. KPFM revealed a 0.404 eV work-function difference between C3N4 and Co3O4, while SPV, photocurrent, PL, and EIS measurements consistently showed enhanced photoinduced charge separation after MMT incorporation. Component-control experiments identified Co-containing sites as the primary direct PMS activation centers, with C3N4 supplying photogenerated carriers and MMT regulating the defect-rich interfacial environment and Co-site stability. MCNCo/PMS/Vis followed a photogenerated-charge-assisted radical pathway in which •OH and SO4•–contributed 47.76 and 22.67%, respectively, whereas 1O2 contributed 0.05%. Although MCNCo and CNCo reached the same final PMS decomposition efficiency (80.36%), MCNCo showed the higher PMS utilization index (0.139 versus 0.115), consistent with its sustained BPA oxidation. MCNCo also maintained catalytic activity over ten cycles, and TOC removal increased to 72.63% at 300 min. These results establish layered MMT as an interfacial regulator that couples defect control, charge transfer, and Co-mediated PMS activation.Keywords
Funding Information
- Graduate Program in Physics at UNIFAL-MG (2021MS05018)
- Graduate Program in Physics at UNIFAL-MG (2025MS02008)
- Graduate Program in Physics at UNIFAL-MG (22166027)
- Graduate Program in Physics at UNIFAL-MG (52164024)
This publication has 59 references indexed in Scilit:
- Nanoporous Zero‐Valent Transition Metals for Enhanced Peroxymonosulfate Activation toward Phenolic Pollutants Degradation: Performance, Pathways, and DFT Mechanism StudySmall, 2026
- Encapsulating asymmetrically coordinated Co single-atoms and clusters in millimetric ZSM-5 for short-pathway Fenton-like catalysisApplied Catalysis B: Environment and Energy, 2026
- Cation Exchange Capacity Controlled Exfoliation of Monolayer Montmorillonite as Inorganic Liquid CrystalsSmall, 2025
- Nanoconfined heterogeneous catalysis triggered by copper oxide supported metal–organic framework UiO-66-NH2/peroxymonosulfate for rapidly removing bisphenol A in waterJournal of Materials Science, 2024
- Unraveling the Fundamentals of Axial Coordination FeN 4+1 Sites Regulating the Peroxymonosulfate Activation for Fenton‐Like ActivitySmall, 2024
- Interface and Defect Engineering in 3D Co3O4‐Ov/TiO2 to Boost Simultaneous Removal of BPA and Cr(VI) upon Photoelectrocatalytic/Peroxymonosulfate (PEC/PMS) SystemAdvanced Functional Materials, 2024
- M−N3 Configuration on Boron Nitride Boosts Singlet Oxygen Generation via Peroxymonosulfate Activation for Selective OxidationAngewandte Chemie International Edition, 2024
- Designing 3D‐MoS2Sponge as Excellent Cocatalysts in Advanced Oxidation Processes for Pollutant ControlAngewandte Chemie International Edition, 2020
- Cobalt-catalyzed sulfate radical-based advanced oxidation: A review on heterogeneous catalysts and applicationsApplied Catalysis B: Environment and Energy, 2016
- Photodegradation of bisphenol A by highly stable palladium-doped mesoporous graphite carbon nitride (Pd/mpg-C3N4) under simulated solar light irradiationApplied Catalysis B: Environment and Energy, 2013