Defect reduction strategies for the manufacture of contoured laminates using vacuum BAG‐only prepregs
Authors:
- 7 September 2015
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 38 (9) , 2016-2025
Abstract
Complex structures manufactured using low‐pressure vacuum bag‐only (VBO) prepreg processing are more susceptible to defects than flat laminates because of complex compaction conditions present at sharp corners. Consequently, effective defect mitigation strategies are required to produce structural parts. In this study, we investigated the relationships between laminate properties, processing conditions, mold designs, and part quality in order to develop science‐based guidelines for the manufacture of complex parts. Generic laminates consisting of a central corner and two flanges were fabricated in a multipart study that considered variation in corner angle and local curvature radius, the applied pressure during layup and cure, and the prepreg material and laminate thickness. The manufactured parts were analyzed in terms of microstructural fiber bed and resin distribution, thickness variation, and void content. The results indicated that defects observed in corner laminates were influenced by both mold design and processing conditions and those optimal combinations of these factors can mitigate the defects and improve quality. POLYM. COMPOS., 38:2016–2025, 2017. © 2015 Society of Plastics EngineersKeywords
This publication has 16 references indexed in Scilit:
- A review of out-of-autoclave prepregs – Material properties, process phenomena, and manufacturing considerationsComposites Part A: Applied Science and Manufacturing, 2015
- Formation of voids in composite laminates: Coupled effect of moisture content and processing pressurePolymer Composites, 2014
- Out-of-autoclave prepreg consolidation under deficient pressure conditionsJournal of Composite Materials, 2013
- Effect of room-temperature out-time on tow impregnation in an out-of-autoclave prepregComposites Part A: Applied Science and Manufacturing, 2013
- Measuring the impregnation of an out-of-autoclave prepreg by micro-CTComposites Science and Technology, 2011
- Void formation in composite prepregs – Effect of dissolved moistureComposites Science and Technology, 2010
- Spring-in and warpage of angled composite laminatesComposites Science and Technology, 2002
- Aspects of the Compaction of Composite Angle Laminates: An Experimental InvestigationJournal of Composite Materials, 2001
- Effect of void content on the strength of composite laminatesComposite Structures, 1994
- Void Effects on the Interlaminar Shear Strength of Unidirectional Graphite-Fiber-Reinforced CompositesJournal of Composite Materials, 1992