Calculation Based on the Formation of Mg2Si and Its Effect on the Microstructure and Properties of Al–Si Alloys
Open Access
Abstract
In order to investigate the effect of Mg2Si formation on the microstructure and properties of an Al−Si alloy, the critical point of a hypereutectic Al−17Si−4Cu−Mg alloy was calculated by Pandat software. The calculation results of the equilibrium phase diagram show that the critical point for Mg2Si phase formation for the alloy was obtained when the Mg content was 2.2%. The contents of 0.5 wt.% Mg and 2.5 wt.% Mg were selected as the research object. The content of Mg increased from 0.5 wt.% to 2.5 wt.%, the eutectic Si in the matrix was reduced, and the Chinese character-like Mg2Si phase appeared in the microstructure. In the peak ageing state, in addition to θ″ and Q′ phases that were mainly precipitated, there was also needle-like β″ precipitation in the 2.5 wt.% Mg content alloy. Larger precipitates were found in 2.5 wt.% content alloys, mainly due to the promotion of the solid solution having the aggregation and segregation of more solute elements in the matrix. The tensile strength, elongation, and hardness of hypereutectic Al−17Si−4Cu−0.5Mg alloy under peak ageing were 331 MPa, 3.11%, and 152.1 HB, respectively. The tensile strength and the elongation decreased while the hardness increased with the 2.5 wt.% Mg content, which is due to the formation of hard and brittle Mg2Si and Al8FeMg3Si, which has a splitting effect on the matrix.Keywords
Funding Information
- National Natural Science Foundation of China (No.51974092)
- Key-Area Research and Development Program of Guangdong Province (No.2020B010186002)
- Guangdong Provincial Key Laboratory of Advanced Forming of Light Metal Materials (No.2021B1212050001)
This publication has 30 references indexed in Scilit:
- Effect of Mg level on the microstructure and mechanical properties of die-cast Al–Si–Cu alloysMaterials Science and Engineering: A, 2015
- Enhanced mechanical properties of an Al–Si–Cu–Mg alloy at 300°C: Effects of Mg and the Q-precipitate phaseMaterials Science and Engineering: A, 2015
- Microstructure and mechanical properties of thixoformed A319 aluminium alloyMaterials & Design (1980-2015), 2014
- Compositional evolution of Q-phase precipitates in an aluminum alloyActa Materialia, 2014
- Mechanical behavior and strengthening mechanisms in ultrafine grain precipitation-strengthened aluminum alloyActa Materialia, 2014
- The effect of Mg on the structure and properties of Type 319 aluminum casting alloysActa Materialia, 2009
- Ageing behaviour of A356 alloy reinforced with in-situ formed TiB2 particlesMaterials Science and Engineering: A, 2008
- The crystal structure of the β′ phase in Al–Mg–Si alloysActa Materialia, 2007
- Secondary solidification behaviour of the Al–Si–Mg alloy prepared by the rheo-diecasting processActa Materialia, 2007
- The effect of Cu additions on the precipitation kinetics in an Al-Mg-Si alloy with excess SiMetallurgical and Materials Transactions A, 2001