Development of polymer electrostatic comb-drive actuator using hot embossing and ultraprecision cutting technology
Authors:
- 1 October 2009
- journal article
- Published by SPIE-Intl Soc Optical Eng in Journal of Micro/Nanolithography, MEMS, and MOEMS
- Vol. 8 (4) , 043065-043065-5
Abstract
We report the fabrication and evaluation of a PMMA electrostatic comb-drive microactuator using hot embossing and ultra-precision cutting technology. First, a two-step silicon mold is fabricated by bulk micromachining technology. Next, comb-drive microactuator structures are formed on a PMMA plate by hot embossing. Both finger width and gap between fingers are , and finger thickness is larger than . Then, the PMMA layer that remained after hot embossing is removed by ultra-precision cutting to release the movable parts. Last, the device is coated with a gold layer for the electrode. The PMMA comb-drive microactuator has been tested successfully.
Keywords
This publication has 6 references indexed in Scilit:
- Low‐temperature direct bonding of poly(methyl methacrylate) for polymer microchipsIEEJ Transactions on Electrical and Electronic Engineering, 2007
- Fabrication and Characterization of Smooth Si Mold for Hot Embossing ProcessIEEJ Transactions on Sensors and Micromachines, 2007
- Design and Fabrication of Polymer Electrostatic Comb-Drive Actuators for Micro Conveyer SystemsIEEJ Transactions on Sensors and Micromachines, 2006
- Fabrication of high-aspect-ratio polymer-based electrostatic comb drives using the hot embossing techniqueJournal of Micromechanics and Microengineering, 2003
- Multiple-height Microstructures Fabricated by ICP-RIE and Embedded Masking LayersIEEJ Transactions on Sensors and Micromachines, 2000
- Ultrasonic Elliptical Vibration CuttingCIRP Annals, 1995