High stereographic resolution texture and residual stress evaluation using time-of-flight neutron diffraction
Open Access
- 9 May 2018
- journal article
- research article
- Published by International Union of Crystallography (IUCr) in Journal of Applied Crystallography
- Vol. 51 (3) , 746-760
Abstract
Neutron diffraction texture measurements provide bulk averaged textures with excellent grain orientation statistics, even for large-grained materials, owing to the probed volume being of the order of 1 cm3. Furthermore, crystallographic parameters and other valuable microstructure information such as phase fraction, coherent crystallite size, root-mean-square microstrain, macroscopic or intergranular strain and stress, etc. can be derived from neutron diffractograms. A procedure for combined high stereographic resolution texture and residual stress evaluation was established on the pulsed-neutron-source-based engineering materials diffractometer TAKUMI at the Materials and Life Science Experimental Facility of the Japan Proton Accelerator Research Center, through division of the neutron detector panel regions. Pole figure evaluation of a limestone standard sample with a well known texture suggested that the precision obtained for texture measurement is comparable to that of the established neutron beamlines utilized for texture measurement, such as the HIPPO diffractometer at the Los Alamos Neutron Science Center (New Mexico, USA) and the D20 angle-dispersive neutron diffractometer at the Institut Laue–Langevin (Grenoble, France). A high-strength martensite–austenite multilayered steel was employed for further verification of the reliability of simultaneous Rietveld analysis of multiphase textures and macro stress tensors. By using a texture-weighted geometric mean micromechanical (BulkPathGEO) model, a macro stress tensor analysis with a plane stress assumption showed a rolling direction–transverse direction (RD–TD) in-plane compressive stress (about −330 MPa) in the martensite layers and an RD–TD in-plane tensile stress (about 320 MPa) in the austenite layers. The phase stress partitioning was ascribed mainly to the additive effect of the volume expansion during martensite transformation and the linear contraction misfit between austenite layers and newly transformed martensite layers during the water quenching process.Keywords
Funding Information
- Japan Society for the Promotion of Science (JP17K06852)
This publication has 48 references indexed in Scilit:
- Texture analysis at neutron diffractometer STRESS-SPECNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2011
- Diffraction study of the retained austenite content in TRIP steelsMaterials Science and Engineering: A, 2011
- Current Status of Engineering Materials Diffractometer at J-PARCMaterials Science Forum, 2011
- Strain and stress tensors of rolled uranium plate by Rietveld refinement of TOF neutron-diffraction dataMaterials Science and Engineering: A, 2010
- Through-thickness texture profiling by energy dispersive synchrotron diffractionJournal of Applied Crystallography, 2010
- POWTEX – the high-intensity time-of-flight diffractometer at FRM II for structure analysis of polycrystalline materialsJournal of Applied Crystallography, 2008
- The D20 instrument at the ILL: a versatile high-intensity two-axis neutron diffractometerMeasurement Science and Technology, 2008
- Reliability criteria in quantitative texture analysis with experimental and simulated orientation distributionsJournal of Applied Crystallography, 2005
- Method for the simultaneous determination of anisotropic residual stresses and texture by x-ray diffractionJournal of Applied Physics, 1994
- Neutron Diffraction Texture Analysis Using a 2θ‐Position Sensitive DetectorTexture, Stress, and Microstructure, 1982